Schneider Electric IMT47270 Thorsman LED Worklamps Instruction Manual

**Schneider Electric IMT47270 Thorsman LED Worklamps Instruction Manual

**

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

Safe electrical installation must be carried out only by skilled professionals. Skilled professionals must prove profound knowledge in the following areas:

• Connecting to installation networks.
• Connecting several electrical devices.
• Laying electric cables.
• Safety standards, local wiring rules and regulations

Failure to follow these instructions will result in death or serious injury

DANGER

EQUIPMENT OPERATION HAZARD

• Protect the power cable from sharp edges, heat, and oil.
• Always close the socket lid properly to ensure IP rating.

CAUTION

• The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
• Avoid looking directly into the beam of light which might result in dazzling.
• The external flexible cable or cord of thisluminaire cannot be replaced; if the cord is damaged, the luminaire should be destroyed

Failure to follow these instructions can result in injury or equipment damage.

Technical data

• Ambient temperature:
  40°C

• Documentation for the product contained within:
  This product contains a light source of energy efficiency class

• No-load power consumption :
  <0.1W

• Efficiency at low load (10 %):
  78% (typical)

• Average active efficiency:

  80%

For IMT47279

Hibernate mode: lamp off, no power output from type A and type C USB outlets.

Normal mode: short press to turn on/dim/off the lamp, type A and type C USB outlets remains on.

Normal mode to Hibernate mode (only when batterypowered): long press the power button for 3 seconds, all LED indicators will flash 3 times.

Hibernate mode to Normal mode:

1. Connect the worklamp to the mains power, or
2. Short press the power button (battery-powered)

WARNING

EXPLOSION, FIRE, OR CHEMICAL HAZARD

• Never attempt to replace the rechargeable battery. The battery must be replaced by the manufacturer or qualified electrical personnel only.
• Deep discharge may risk damaging the battery.
• The luminaire is not intended for use as a portable emergency light.

Failure to follow these instructions can result in death, serious injury, or equipment damage.

LED indicator for IMT47279

then return to their original state.
Sleep mode (No power output from Type A and Type C USB outlets, and the lamp remains off)|

1. LED1 flashes for one minute andturns off.
2. If you short press the powerbutton, LED1 flashes for 10 seconds,then it turns off.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>