NOTIFIER BG-10 Pull Station Locking Safety Clip Instructions
- June 9, 2024
- NOTIFIER
Table of Contents
NOTIFIER BG-10 Pull Station Locking Safety Clip
BG-10 Locking Safety Clip Installation
Document 51329 Rev. A 3/22/00 ECN: 00 – 114
General Information
The Locking Safety Clip is an enhancement to the operation of the BG-10 Series Pull Station. Its purpose is to increase the “tamper” resistance of the pull station. The safety clip does not allow an activated pull station to be forced back into the inactivated position, without first unlocking and opening the pull station door.
Safety Clip Installation
- Open the BG-10 pull station cover-door using the key or appropriate hex wrench. The open door will rest in a perpendicular position to the attached mounted back-plate.
- Holding the door as shown in Figure 1, snap the locking clip into position over the end of the activating handle. Figure 2 shows the locking clip installed in the correct position.
- Close and lock the BG-10 pull station cover-door.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>