Bell Arella 400 Wireless Turn Signal Bicycle Tail Light Instruction Manual

Bell Arella 400 Wireless Turn Signal Bicycle Tail Light Instruction Manual

Tail Light Installation

1. Click light securely into mount.
2. Place mount on seatpost at desired position.
3. Wrap silicone strap around seatpost and hook in place.
4. Tilt light to position straight up and down.
   

Charging

Note: Charg fully before first use

Remove protective cover, exposing the charge port. Plug in USB cable to charge.

Green LED turns off when fullycharged. Unplug USB cable and secure cover.

Handlebar Remote Installation

1. Place remote on handlebar at desired position.
2. Wrap the silicone strap around the handlebar and hook in place.
   

Use

1. Turn the tail light on first by pressing the power button. Blue LED will turn on indicating it is ready.
2. On the remote, press desired use. LED indicators on remote will show what the tail light is projecting.
3. Turn off tail light when not in use. All LEDs including blue LED should be off.

Battery Replacement

Use a coin to pop open the remote, slide out and replace battery.

FCC INFORMATION

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 5 mm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

ATTACHING THE PRODUCTES TO THE HEADER (not triangle card)

Place folded cable onto the package and secure with zip tie.

Place tail light into square hole. Slide strap onto the base and lock Into place.

Place remote into upper left hole and secure with silicone strap and lock with zip tie.

NEED MOCKUP FOR VENDOR INSTRUC-TION AND TO MAKE SURE COPY ISN’T COVERED

logo =60% black
Gloss AQ
CMYK Black background

PACKAGE MATERIAL: 250G + 450G GREY BOARD +250G

PLEASE USE NEW DRAW DOWNS TO PROOF COLORS.

Support

© 2021 BELL SPORTS, INC. / 1-800-456-BELL 1001 INNOVATION ROAD / RANTOUL, IL 61866 USA MADE IN CHINA

INCLUDES: ONE (1) TAIL LIGHT, ONE (1) LI-POLY BATTERY, MOUNTING HARDWARE, MICRO-USB CHARGING CABLE, REMOTE CONTROL,ONE (1) CR2032 BATTERY, MOUNTING STRAP

FOR WARRANTY DETAILS: WWW.THEBELLGARAGE.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>