TiGHT AV AU-X2O-DA Dante 2CH XLR Output Adapter User Manual
- June 4, 2024
- TIGHT AV
Table of Contents
TiGHT AV AU-X2O-DA Dante 2CH XLR Output Adapter
Product Introduction
Thanks for choosing the AU-X2O-DA. The device outputs 2 channels of analog line level audio from your Dante network, supporting sampling rates up to 96kHz, using Audinate’s original Dante Ultimo chip.
Features
- Plug and Play
- Dante and AES67 support
- 24-bit audio support
- 0X2 audio channels
- Supports 802.3af PoE
Packing List
- 1x AU-X2O-DA
- 1x User Manual
Panel Description
① RJ45: Dante network communication port. Green steady light indicates
link; yellow flashing light indicates data traffic. The green light will flash
to identify the device when clicking the Dante Controller “Identify” button
(an eye-shaped symbol) on the host computer
② XLR: 2 x XLR-M connectors, for output signal
Customer Service
We provide limited warranty for the product within five years counting from date of purchase (The purchase invoice shall prevail).
Note: Please contact your distributor immediately if any damage or defect in the device is found.
Technical Specification
Audio
Max signal level| +18 dBu / +4 dBu / 0 dBu 0 dBV /-10 dBV
Frequency Response| 20Hz to 20kHz (-/+0.5dB)
Impedance| 150 Ohm balanced
75 Ohm unbalanced
Dynamic Range| >100 dB
Signal to Noise Ratio| >100 dB
THD| <0.01% @+4 dBu
Dante
Sample Rate| 44.1kHz, 48kHz, 96kHz
Bit Depth| 24
Dante Device Latency| 1, 2 or 5ms (configurable using Dante Controller)
Network Transport| Dante Audio over IP AES67 RTP
Model Name| AU-X2O-DA
General
Operation Temperature| -5 to +55 (+23° to +131°F)
Storage Temperature| -25 to +70℃ (-13° to +158°F)
Power| 802.3af PoE
Power Consumption| 2.6W (Max)
Dimension (WHD)| 30 x 28 x 114 mm
Cable length| 300mm
Net Weight| 145g
Compliance| FCC, CE
Environmental| RoHs, WEEE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>