City Lights P1791 Spiked Pendant Light Instruction Manual

: June 9, 2024
: City Lights

Table of Contents

City Lights P1791 Spiked Pendant Light
INSTALLATION INSTRUCTION FOR FIXTURE #P1791, P1792
ASSEMBLY THE FIXTURE
Read User Manual Online (PDF format)
Download This Manual (PDF format)

City Lights P1791 Spiked Pendant Light

City-Lights-P1791-Spiked-Pendant-Light-PRODACT-IMG

INSTALLATION INSTRUCTION FOR FIXTURE #P1791, P1792

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

ASSEMBLY THE FIXTURE

City-Lights-P1791-Spiked-Pendant-Light-FIG-1

Shut off the power at the fuse box or circuit breaker. If necessary, remove the existing fixture and its mounting hardware from the ceiling.
Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
Determine the rod length if necessary, then assemble the rod (C) together using nipple (E) , then assemble the small rod (D) onto the rod (C) , after that, assemble the bottom end of the rod (D) onto the coupling (B) and assemble the small loop (F) onto the top end of the rod (C).
Assemble the crystal bar (A) onto nipple (O) well.
Install the bulb (N) (not included) in accordance with the fixture’s specifications. (DO NOT EXCEED THE MAXMUM WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Connect the small loop (F) and (I) using the chain quick link (G) well.
Attach the cross bar (M) to the outlet box using the outlet box screws (K). The side of the mounting bar marked “GND” must face out.
Follow the wiring instructions carefully (See Fig.2).
Attach the fixture main body onto outlet box by protruding mounting screws (L) through mounting holes on the canopy and secure with ball nut (J).
CONNECTING THE WIRES
Connect the electrical wires as follows. Connect the smooth wire from the fixture to the smooth (HOT) house wire. Connect the ribbed wire from the fixture to the ribbed (Neutral) house wire. Make sure all the wire nuts were secured. You may wrap the connections with electrical tape. If your outlet box has a ground wire (Green or Bare Copper) connect fixture’s ground wire to it. Other wise attach the bare copper fixture wire to the green ground screw on the mounting bar.
Tuck the wire connections neatly into the ceiling junction box. Your installation is now complete. Turn on the power supply of the junction box to test the fixture.