SWIT CL-100 LED Studio Panel LED Light User Manual

SWIT CL-100 LED Studio Panel LED Light User Manual

http://www.swit.cc
contact@swit.cc

Thank you for choosing SWIT products, Please read the instructions before using and keep it for future reference.

Specification

Cautions

1. Do not disassemble the panel light or touch the interior with metal objects to avoid damage;
2. Do not store the panel light in dusty or wet environment to avoid damage:
3. In order to ensure safety, please use the safety rope when hoisting the lamp:
4. Only use the light in the temperature range of -10°C-40°C.

Appearance

1. AC IN 
2. DMX IN
3. USB  11 Barn Door 
4. DMX OUT  
5. LCD Display 
6. Intensity Adjustment knob
7. Power switch
8. AC OUT
9. Pitch Angle Adjustment knob
10. 11. Honeycomb Mounting Hole
    12. Bracket Adaptor
    13. Diffuser
    14. U-Shape Bracket

Usage

1. Install
   Before use, install the honeycomb as required (optional parts, installation mode as shown in Figure 6), please use with safety rope when hoisting lights, safety rope should through the U-shaped bracket and the lifting ring (the lifting ring shall be installed in the mounting hole of the lifting ring at the top of the light).

2. Power Supply
   The working voltage of CL-100 is AC 100-240V,50/60Hz, support AC loop out.

3. Brightness & DMX address setting
   This product is 5600K single temperature panel light, user can adjust the Intensity with DMX light controller according to requirement after connecting power. For Example:

• DMX Control
  Each light occupies a total of one DMX channel. If the DMX address set on the light is N, then the N channel on the DMX light console controls the intensity parameters of the light. If the DMX address set on the light is 001, then the relevant control channel and functions of the light console are shown as below:

• DMX Address setting
  Long press the brightness adjusting knob (Fig.46) for 2s to enter in communication address setting interface, communication address range: 001-512. LCD digital tube field flashing indicates that the current bit is selected, rotate the brightness adjustment knob (Fig.4 6)to set the current bit, press the brightness adjustment knob (Fig.4)to set the current bit, press the brightness adjustment knob[Fig.4)to determine the setting of the current bit and go to the next bit, when the setting of the last bit is completed, press the brightness adjustment knob(Fig 4 )or wait for about 5s, to exit the setting of the communication address.

Packing List

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>