Premium Spec Selectable LED Round Bollard Instruction Manual

Table of Contents

WARNING

Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
To reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards, read all warnings and instructions included with and on the fixture box and all fixture labels.
Proper grounding is required to ensure safety.
Power must be turned off at the breaker before installation or maintenance.
Installation, service, and maintenance of luminaires should be performed by a qualified licensed electrician.
Wear gloves and eye protection at all times while installing, servicing, or performing maintenance on the luminaire, and avoid direct eye exposure to the light source while it is on.
Do not install damaged product. Inspect luminaire for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.
These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.

WARNING

CAUTION

Install this product in accordance with country, regional and local laws and regulations.
If unsure about the installation or maintenance of this product, consult a qualified electrician and check the local electrical code.
Inspect equipment for damage from shipping and handling.

Remove the luminaire (Fig 1) and accessories (Fig 2) from the carton and inspect for damage. Do not install a damaged luminaire.

Premium-Spec-Selectable-LED-Round-Bollard-Instruction-
FIG-1

Prepare site. Assemble the anchor bolt carrier (Fig 3) and use it to determine the placement of the anchor bolts in the concrete.
Ensure that concrete base is suitable for the load of the bollard.
Install the three anchor bolts into the concrete having at least 1-1/2” – 2” protruding from the concrete with the threads free and clear of debris and dirt. (Fig 4)
Disassemble the fixture body from the base plate by loosening the three set screws with the hex wrench. (Fig 5)
Lay the fixture body down beside the installed anchor bolts. Make sure to keep the wires connected. (Fig 6)
Place the base plate over the anchor bolts and tighten the nuts to secure the base plate to the foundation. (Fig 7)
Connect the incoming power leads to the fixture according to the Wiring Diagram. Verify all wiring is properly connected and properly secured.
Replace the fixture body on the base plate and tighten the three set screws with hex wrench to secure the fixture body to the base plate. (Fig 8)
Set the desired color temperature (CCT) and wattage using the following steps: (Fig 9)
- Use the hex wrench to open the bollard head.
- Select the desired CCT and wattage using the switches.
- Replace the bollard head and secure it using the hex wrench.
- Defult CCT Setting : 22W, 5000K
Power on the luminaire.

Premium-Spec-Selectable-LED-Round-Bollard-Instruction-
FIG-8 Cleaning Recommendations

Wipe off dust with a dry, soft cloth.
Remove greasy spots with a soft cloth dampened in lukewarm water (<122°F/ 50°C) with a mild detergent.
Never use detergents containing abrasives or solvents.
Never use scouring powder and similar substances as they will scratch the surfaces of the bollard.