Premium Spec LEDHBAY1000051316 UFO High Bay Instruction Manual

Table of Contents

WARNING

Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
To reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards, read all warnings and instructions included with and on the fixture box and all fixture labels.
Proper grounding is required to ensure safety.
Power must be turned off at the breaker before installation or maintenance.
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Wear gloves and eye protection at all times while installing, servicing, or performing maintenance on the luminaire, and avoid direct eye exposure to the light source while it is on.
Do not install damaged product. Inspect luminaire for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.
These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.

WARNING
If there is smoke or fire, please turn off the power immediately and consult a qualified electrician.

CAUTION

Please use listed water proof strain relief busing when connecting the supply cord to the outlet box.
Do not use an electric generator to test the LED light.

Hook Mount

Screw the hook into the fixture and tighten. (Figure 1)
Hang the fixture on the ceiling hook. (Figure 2)
Connect to the power according to local laws and regulations. Ensure the connect is stable and protected.

Premium-Spec-LEDHBAY1000051316-UFO-High-Bay-02

DC Motion Sensor

Use a screwdriver to remove the 1/2″ NPT plug to expose the motion sensor receptacle.
Push the motion sensor into the receptacle.
Default programs have been set for motion sensor and PIR prior to shipment. It needs to be re-set by remote control if you need to change the working mode. The remote control is an optional accessory. (Figure 3-1)

Premium-Spec-LEDHBAY1000051316-UFO-High-Bay-03

This fixture features 3 CCT selectable switching. Lift the water proof gasket to expose the CCT dip switch.
Set the light to your desired CCT and push the water proof gasket back in place. (Figure 3-2)
A dip switch allows you to choose between down-lighting or both up and down lighting.

Premium-Spec-LEDHBAY1000051316-UFO-High-Bay-04

972-535-0926 pltsolutions.com ver 112322

| Premium Spec LEDHBAY1000051316 UFO High Bay [pdf] Instruction Manual
LEDHBAY1000051316 UFO High Bay, LEDHBAY1000051316, UFO High Bay, High Bay, Bay
---|---