WeteLux 82 14 52 Solar Pond Aerator Instruction Manual

June 9, 2024
WeTeLux

WeteLux-LOGO

WeteLux 82 14 52 Solar Pond Aerator

DESCRIPTION

WeteLux-82-14-52-Solar-Pond-Aerator-FIG-1

  1. Pump
  2. Solar Module
  3. Solar Module Holder
  4. Extension Piece
  5. Ground Stake
  6. Air Hose
  7. Aeration Stone

SAFETY NOTES

Please note the included General Safety Notes and the following safety notes to avoid malfunctions, damage or physical injury:

  • Please read this manual carefully and use the device only according to this manual.
  • Dispose of used packaging material carefully or store it out of the reach of children. There is a danger of suffocation!
  • Persons with limited physical, sensorial or mental abilities are not allowed to use the device, unless they are supervised and briefed for their safety by a qualified person.
  • The solar pond aerator is not a toy. Keep it out of reach of children.
  • Treat the solar module as a glass product. Do not walk on it.
  • Do not operate the pump under water. Place the pump at the pond edge at a dry and flood protected place.
  • Make sure the air hose and the power cord cannot become a tripping hazard.
  • Do not continue to use the unit if the pump or the solar module becomes damaged. Repair work must be done by a qualified service technician.
  • Do not disassemble the unit or attempt to repair it yourself. It does not contain parts serviceable by you. In case of questions or problems, please turn to our customer support.

Operation

Intended Use
The pond aerator is designed for light water circulation and thus for oxygenation of small garden ponds. In summer when high temperatures are present, a kind of “film” can build up on the pond surface and the surface does not absorb oxygen. The oxygen level decreases. Due to the rising air bubbles created by the pond aerator, the pond surface is constantly in motion and oxygen can be absorbed at the surface. Install the pump on the edge of the pond. The pump is powered via the solar module and operated independently from the mains in direct sunlight. The pump pumps the air through a 2 meter silicone tube to the aeration stone. Using the ground stake the solar panel can be attached on the ground.

Assembling and Using

  1. Connect the plug of the pump cable (1) to the socket at the rear of the solar module (2). Adjust the front side of the solar module directly towards the position of the sun at noontime. Setup the solar module by using the ground stake (5) that can be extended with the extension piece (4). Attach the solar module holder (3) to the top part of the solar module (see picture on the right). Avoid any form of shading in order to achieve the highest possible yield.
  2. Put the aeration stone (7) on the one end of the air hose (6).
  3. Connect the other end of the air hose to the pump (1).
  4. Roll out the cable of the pump and install the pump on the edge of the pond.
  5. Put the aeration stone into the pond (approx. 30 cm below the pond surface). If possible, put the aeration stone on top of some stones in the pond and not directly onto the ground level of the pond to avoid soiling of the capillary pin holes of the stone.

Notes:

  • The performance of the pump depends on the season and on the position and orientation of the solar module. If there is too little sunlight, the pump may not start. In this case please use a different method to aerate the pond.
  • Keep the openings of the pump free from any obstructions. Do not operate the pump under water.
  • Clean the aeration stone in regular intervals.
  • The surface of the solar module is made of glass. Be careful when assembling the system. Do not break it. There is risk of injury. A broken module cannot be repaired it has to be disposed of environmentally compatible.
  • During the winter time store all components of the solar pond aerator indoors at place that is protected from dust, dirt and extreme temperatures. Clean all parts thoroughly before storing.

Cleaning the Solar Module

  • Soiling on the front-side of the glass surface will reduce the incidence of light onto the solar cells and this will decrease the output of electrical power.
  • In case of heavy soiling, clean the glass with usual glass cleaners. To avoid scratching the glass surface, use plenty of water and a soft brush or a cloth.
  • Check the electrical cables at regular intervals for any form of damage or corrosion and for firm fit on the cable connections.

Technical Data

Pump:

  • Nominal Voltage : 6 V
  • Nominal Power : 0,7 W
  • Max. Air Volume : 100 l/h
  • Power Cord Length : 3 m
  • Air Hose Length : 2 m
  • Degree of Protection : IP44

Solar Module:

  • Pmpp : 0,7 W
  • Umpp : 5V
  • Impp : 120 mA
  • UOC : 6 V
  • ISC : 140 mA
  • Dimensions : 17,5 x 13 x 2 cm
  • Weight : 241 g

DECLARATION OF CONFORMITY

declare by our own responsibility that the product Solar Pond Aerator is according to the basic requirements, which are defined in the European Directives and their amendments

2011/65/EU
Restriction of the Use of certain hazardous Substances in electrical and electronic Equipment (RoHS)

2014/30/EU
Electromagnetic Compatibility (EMC) EN 61000-6-1:2007, EN 61000-6-3:2007+A1+AC

The technical documentations are on file at the QA department of the Westfalia Werkzeugcompany.

CUSTOMER SERVICES

DEUTSCHLAND
Westfalia Werkzeugstraße 1 D-58093 Hagen

  • Telefon : (0180) 5 30 31 32
  • Telefax : (0180) 5 30 31 30
  • Internet : www.westfalia.de

ÖSTERREICH
Westfalia Moosham 31 A-4943 Geinberg OÖ

SCHWEIZ
Westfalia Wydenhof 3a CH-3422 Kirchberg (BE)

DISPOSAL

Dear Customer, Please help avoid waste materials. If you at some point intend to dispose of this article, then please keep in mind that many of its components consist of valuable materials, which can be recycled. Please do not discharge it in the rubbish bin, but check with your local council for recycling facilities in your area.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals