BaByliss AS90PE Smooth Volume Air Instruction Manual
- June 9, 2024
- BaByliss
Table of Contents
BaByliss AS90PE Smooth Volume Air
Read the safety instructions first.
HOW TO USE
- Ensure your hair is 80% dry and combed through to remove any tangles. Create your parting and divide the hair into sections ready for styling.
- Secure the selected attachment onto the airstyler.
- Slide the switch to the ‘*’, ‘I’ or ‘II’ position to turn the appliance on and select a heat setting suitable for your hair type.
- After use, slide the switch to the ‘0’ setting to switch off and unplug the appliance.
- Allow the appliance to cool before storing away.
Changing the Attachments
- Place the attachment onto the handle and line up the two indents on the attachment with the buttons on the handle.
- Push the attachment onto the handle until it clicks into place.
- To remove an attachment, press and hold the two buttons on the handle and pull the attachment up and away.
Oval tourmaline-ceramic volumising brush
- Place the brush head underneath the hair section, close to the scalp.
- Use the brush to lift the hair at the roots to create volume.
- Hold in place for 5–10 seconds. Then apply cool air to fix the style in place.
- Slowly move the styler down through the hair, towards the ends.
- Repeat for each section of hair.
Smooth Blow-Dry Brush Attachment
- Place the brush head under a section of hair, close to the root with the bristles pointing upwards.
- Use the other hand to pull the hair section taut against the brush head.
- Gently slide the brush head through the section of hair, until you reach the ends.
- Repeat for each section of hair.
Heat Settings
There are 2 heat settings plus a cool setting. Slide the switch to the first
position to select the cool setting ‘*’, the second position for the low heat
‘I’, and the third position for the high heat ‘II’.
Please note: If you have delicate, fine, bleached or coloured hair, use the
lower heat settings. For thicker hair, use the higher heat setting.
CLEANING & MAINTENANCE
To help keep your appliance in the best possible condition, please follow the steps below:
General
- Ensure the appliance is switched off, unplugged and cool.To clean the outside of the appliance, wipe with a damp cloth. Make sure that no water enters the appliance and it is completely dry before use.
- Do not wrap the lead around the appliance; instead coil the lead loosely by the side of the appliance.
- Do not use the appliance at a stretch from the power point.
- Always unplug after use.
Cleaning the Filter
- Ensure the appliance is switched off, unplugged and cool.
- Holding the handle of the appliance firmly, lift the filter open from the grooves close to the cord bushing. This will enable the rear filter top open.
- Using a soft brush, clean any hair and other debris from the filter.
- Replace the rear filter by closing the lid shut
BABYLISS SARL ZI du Val de Calvigny 59141 Iwuy France
www.babyliss.com
FAC 2022/05
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>