Hunter 19692 Briargrove One Light Wall Sconce Instruction Manual
- June 4, 2024
- Hunter
Table of Contents
Hunter 19692 Briargrove One Light Wall Sconce
INSTALLATION INSTRUCTIONS
- To avoid possible electrical shock, before installing your light fixture, disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location.
READ AND SAVE THESE INSTRUCTIONS These instructions are provided for your safety. It is very important that they are read carefully and completely before beginning installation of the lighting fixture.
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. Shut off the power at the circuit breaker and completely remove the old fixture from the ceiling, including the old mounting bracket. Remove the new mounting bracket assembly from the bag. Then remove cap nuts (A) from mounting screws (B). Place the mounting plate (D) over the junction box so that mounting screws (B) and nuts (E) extend out away from the wall. Depending on the placement of your junction box the position of mounting screws (B) may need to be adjusted to allow the backplate to be flush with the wall. Adjust the position of mounting screws (B) so that mounting screws (B) can be exposed 5-6 mm after passing through the backplate (G) to properly fit the cap nuts. Mounting screws (B) can be adjusted by loosening nuts (E) and loosening or tightening mounting screws (B). Once the ideal position of mounting screws (B) has been confirmed, tighten nuts (E) on mounting screws (B) on the front of the mounting plate to ensure that mounting screws (B) are secure. Pull the house wires through the center of mounting plate (D). Secure mounting plate (D) to the junction box by tightening the screws (F).
CONNECTING THE WIRES
Have a helper support the fixture’s weight while completing the wiring. Attach
the fixtures wires to the power supply wires from the junction box. Connect
black to black (Live); white to white (grounded); grounding to grounding
(green or copper). Twist the ends of the wire pairs together. Then, twist on a
wire connector. Make sure all twists are in the same direction. Loop fixture’s
ground wire around grounding screw (C) and tighten. If there is no ground wire
(green or copper) from the junction box, contact a qualified electrician.
FINISHING THE INSTALLATION
Place the fixture’s backplate (G) over the mounting screws (B) so the threads
protrude through the holes on the front of the backplate. Tightly screw the
cap nuts (A) onto the mounting screws (B) until the backplate (G) of the
fixture is snugly against the wall. Slide candle sleeve (I) onto socket (J).
Install the shade (H) on candle sleeves (I). Install light bulb (not included)
in accordance with the fixture’s specifications. (Do not exceed the
recommended wattage.) Your installation is now complete. Turn on the power and
test the fixture.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>