HATOR HTM-315 Pulsar Wireless Black User Manual

June 9, 2024
HATOR

HTM-315 Pulsar Wireless Black
User Manual

Gaming mouse
Hator Pulsar Wireless

Safe measures

Bator uses in production only quality components and parts that comply with accepted quality standards and guarantees no defects in materials and workmanship in the equipment for the time specified on the product packaging, starting from the date of purchase in the retail network.
At the same time, please read this manual carefully before using the device, and follow these rules. The device intended for use with household or office digital equipment is a commercial product and can be operated in the temperature range +5…+40°C and relative humidity up to 70%.
The device is designed for individual use indoors. Not intended for use with Industrial equipment, as well as in production facilities. Any changes to the device or non-standard use of the device that are not agreed with the manufacturer or the manufacturer’s representative, remove from the manufacturer and seller any liability for the free warranty service and the consequences of such actions.
You can not open or modify the product. The device is not intended for use by persons with reduced physical, sensory or mental capabilities, unless controlled by other persons responsible for their safety. Be careful! Keep up to following safety regulations:

  • The device has small parts: infant’s and pets access should be limited to them;
  • Use only the accessories specified by the manufacturer;
  • Clean only with dry cloth or special cloths;
  • Do not expose to temperatures above 60°C;
  • Do not expose the device to direct sunlight for a long time, prevent liquid from entering.

Sometimes Incorrect installation and use of the device can be mistaken for Its malfunction. If the device does not work correctly, contact the support at www.hator.gg or the nearest service center listed on the warranty card provided by the seller.

Specification

AppearanceHATOR HTM-315 Pulsar Wireless Black fig
1

Dimensions and specifications

Model| Pulsar Wireless
Product code| HTM-315 HTM-316 HTM-317
HTM-318 HTM-319
Length| 123 mm
Width| 68 mm
Height| 38 mm
Weight| 84 q
Materials| Plastic
Sensor type| Optical
Sensor model| Pixart 3335
Sensor Resolution| 500.1000.1500-2400-4000-8000 16000 CPI
Acceleration| 40G
Polling rate| From 500 to 1000 Hz
Operating Voltage| 5 V
Operating Current| 150 MA
LED type| RGB
Type of connection| 2.4 GHz + USB
Battery Capacity| 700 mA, U-Ion
Usage time| 25 hours at 2.4 GHz mode (Backlight is on)
50 hours at 2.4 GHz mode (Backlight is of)
Operation Distance| up to 10m
Standby| 6 months
L-R Button switch| Kailh 80 min
Encoder| F-Switch
Cable| 1.8 M. with a ferrite filter
System Compatibility| Windows XP/2000/MENista/7/10/11, Android,
Linux and Mac OS
| 2.4 GHz dongle is included

Equiment

  • Mouse
  • 2.4 GHz dongle
  • Manual
  • Replacement glide’s set

Operation of the device

Connect to PC:

  1. Connect the mouse through the USB port, the operating system recognizes the mouse automatically.
  2. If necessary, download the software from the site www.hator.gg/download.
  3. If the PC does not recognize the device, try connecting to a different port.

Switch between wired and wireless mode
Switch to work on operating systems: Windows, Android/I0S, MAC Switch for two connection types: Wired / 2.4 GHz

  1. The device automatically switches to wired mode as soon as the cable is connected.
  2. Disconnecting the cable automatically switches the device to wireless mode.

HATOR HTM-315 Pulsar Wireless Black fig 2

With the switch (OFF), you can turn off the mouse when you don’t need it (for wireless mode only). You can switch to energy-saving mode (ECO).
DPI and Polin. Rate Switch
All indicators light up when the backlight mode is ON.
Setting the DPI
Select the required DPI by pressing the button:
500 – the indicator lights up green
1000 – the indicator lights up blue
1500 – the indicator lights up red (set by default)
2400 – the indicator lights up yellow
4000 – the indicator lights up cyan
8000 – the indicator lights up purple
16000 – the indicator lights up white
Setting the Polling Rate
Select the required by pressing the button:
250 Hz – the indicator lights up blue
500 Hz – the indicator lights up green
1000 Hz – the indicator lights up red (default)

Indicators

Charging mode indicator:
Charging – red light
Fully charged – green light
Low power – red light flash (3 times per second)HATOR HTM-315 Pulsar
Wireless Black fig 3 The mouse will go to sleep mode after 1 minute of not using it. To activate the mouse, move it or press any button.
Connection: 2.4 GHz / Wired
2.4 GHz:
Before the first connection, check the charge level of the device.
To check this press
Left Mouse button – Right Mouse
Button – Scroll Wheel at the same time.
The indicator shows the charge level:
Discharged – red light Half charged – yellow light
Fully charged – green light
When you check the battery level, the mouse does not work until the indicator flashes (about 10 seconds).
Wired : Connect the cable and turn the switch on the back of the mouse to wired mode.
Conditions of transportation and storaie
The device is recommended to be stored in warehouses or in conditions similar to the storage requirements for IT equipment / electronics. The device is recommended to store at a temperature of +5°C to +40°C and humidity up to 70%. The place of storage (transportation) should be inaccessible to moisture, direct sunlight and should exclude the possibility of mechanical damage. In accordance with the terms and conditions of storage, the shelf life of the device in the manufacturer’s original packaging is 10 years. If necessary, transport any kind of civil transport in the available individual consumer packaging.

General restrictions and safet

Use of the product after the end of its service life
The estimated service life of this Hator device is 5 years, but depends in part on the life of the installed switches. This product uses mechanical switches manufactured by Kailh, with a lifetime of 80 million pressures, the lifetime is calculated by the manufacturer based on laboratory data and the specifications of the components used, and is valid only if the user observes the rules of operation, storage and transportation of the product. In case of violation of the operating rules, the actual service life of the device can be reduced. At the end of the life of the product, it is advisable to contact an authorized service center for preventive maintenance of the product and determine its suitability for further operation. Works on the preventive maintenance of the product and its diagnostics are performed by authorized service centers on a paid basis.
Utilization and protection of the environment
The rules for disposal of this product differ from the rules for disposing of household waste. Unlike household waste, the product should be handed over to the appropriate point of reception of electrical and electronic equipment for processing. This contributes to the conservation of natural resources. By observing the rules for the disposal of the product, you prevent possible negative consequences for the environment and human health caused by improper processing. Transfer the device to a specialized waste collection and disposal center or contact the seller from whom the device was purchased. Competent people will send this device to environmentally safe recycling. For improper disposal of waste, fines are provided in accordance with the legislation in force in the country where the device is sold.
Guarantee of the manufacturer (seller)
If the user complies with the operating rules, and taking into account the stipulations stated in this manual, the device provides safety during use but does not cause harmful effects to the environment and the person and is serviceable. The device has a warranty period of operation – 24 months from the date of purchase and without taking into account the time spent in repair (subject to the rules of operation). The right to a guarantee is given when completing the information of the warranty card, which is attached. For more detailed product information, as well as questions and suggestions, please contact the address below. Hator shall bear such liability (at the discretion of Hator’s representatives), which limits your exclusive right to compensation in the event of any breach of warranty obligations through the fault of the buyer, repair or replacement of the product; the refund of the money paid provided that the equipment is returned together with a copy of the goods or a cash voucher to the seller or to the specified address, in accordance with the requirements of the law. The guarantee is in addition to the rights granted under local consumer rights laws. Its conditions vary from country to country. Read the full warranty information to learn about your consumer rights and the additional protection that is provided under this product warranty.

Supplier / Importer in Ukraine:
TOV “NVF “ELETEK LTD”
Address: 33a., Dehtyarivska st., Kyiv
Ukraine, 03057 tel: +38 (044) 538-15-16
Warranty period: 24 months
©2022 Hator. All rights reserved.
All registered trademarks are property of their respective owners.
www.hator.gg

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals