KELLER 23-Ed Series Flameproof Pressure Transmitters User Manual
- June 9, 2024
- KELLER
Table of Contents
KELLER 23-Ed Series Flameproof Pressure Transmitters
Description and Application
Flameproof transmitter for the conversion of pressure into an electrical
signal, for use in hazardous environments.
The characteristics of the pressure transmitter can be taken from the
corresponding data sheet or from the agreed specifications.
Installation
Connector pin assignment 23-Ed / 25-Ed / 33X-Ed / 35X-Ed
Kabelfarbe Cable Colour Couleur de câble
| 23-Ed / 25-Ed| 33X-Ed / 35X-Ed
---|---|---
2-Leiter Wire/ fils| 3-Leiter Wire/ fils| 2-Leiter Wire/ fils|
3-Leiter Wire/ fils| ****
Digital
schwarz black noir| ****
+Vcc
| ****
+Vcc
| ****
+Vcc
| ****
+Vcc
| ****
+Vcc
rot red rouge| ****
+OUT/GND
| ****
+OUT
| ****
n.c.
| ****
+OUT
| ****
n.c.
weiss white blanc| ****
n.c.
| ****
GND
| ****
+OUT/GND
| ****
GND
| ****
GND
blau blue bleu| ****
n.c.
| ****
n.c.
| ****
RS485 A
| ****
RS485 A
| ****
RS485 A
gelb yellow jaune| ****
n.c.
| ****
n.c.
| ****
RS485 B
| ****
RS485 B
| ****
RS485 B
Should the grounding of the transmitter not be guaranteed over the pressure connection, make sure that grounding is provided over the cable shielding.
Service
KELLER pressure transmitters are maintenance-free. The cycle for
recalibration depends on the application conditions. Recommended recalibration
cycle: 1 year.
Safety Instructions
When installing and operating the pressure transmitters, attention should be
paid to the corresponding national safety regulations and to the relative
country regulations concerning the Ex-application.
This product must be installed by authorised personnel only.
Only mount the pressure transmitters onto unpressurized systems.
On pressure ranges > 30 bar, the pressure connections could show residual
hydraulic oil.
Protect the diaphragm against damages.
Transmitters with cable output:
The cable is not longitudinally water-tight: Avoid damages of the cable-
jacket!
Protection IP50, IP65 or IP68, depending on version.
Also note the corresponding data sheet.
Special Conditions for Safe Use
The apparatus is flameproof. It can be used in potentially explosive atmosphere.
Operating ambient temperature:
- T6: -40 °C to +80 °C
- T5: -40 °C to +95 °C
- T4: -40 °C to +100 °C
Marking
- II 2 G Ex db IIC T6 to T4 Gb
- EPS 22 ATEX 1 007X
- IECEx EPS 22.0002X
- EPS 22 UKEX 1 007X
EU / UK DECLARATION OF CONFORMITY
Herewith we declare, that the following products
Flameproof Pressure Transmitters Series 23-Ed, 25-Ed, 33X-Ed and 35X-Ed
comply with the requirements of the following EU/UK Directives:
Directive EMC 2014/30/EU
Directive ATEX 2014/34/EU
Directive RoHS 2011/65/EU and Commission
Delegated Directive (EU) 2015/863
UKSI 2016:1091
UKSI 2016:1107
UKSI 2012:3032
- The Flameproof Pressure Transmitters Series 23-Ed, 25-Ed, 33X-Ed and 35X-Ed omply with the following standards:
EN IEC 61000-6-1:2019 EN IEC 61000-6-2:2019 EN IEC 61000-6-3:2021 EN IEC
61000-6-4:2019
EN 61326-1:2013 EN 61326-2-3:2013 EN IEC 60079-0:2018 EN 60079-1:2014
- The following certificates are given:
EPS 22 ATEX 1 007 X Revision 0 – IECEx EPS 22.0002X Issue No: 0 – EPS 22 UKEX 1 007 X Revision 0
- This declaration is given for the manufacturer:
KELLER Druckmesstechnik AG, St. Gallerstrasse 119, CH-8404 Winterthur
- issued by:
KELLER Gesellschaft für Druckmesstechnik mbH, Schwarzwaldstrasse 17, DE-79798 Jestetten
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>