omthing EO009 AirFree Buds True Wireless Earbuds User Guide
- June 9, 2024
- omthing
Table of Contents
EO009 AirFree Buds True Wireless Earbuds
User Guide
EO009 AirFree Buds True Wireless Earbuds
- It takes about 165 minutes to fully charge the case. The case LED will flash red when charging, and become solid red when charging is complete.
- When case battery is below 20%, the case LED will flash white for 4 seconds after the earbuds have been put back in.
- When case battery is more than 20%, the case LED will be solid white for 4 seconds after the earbuds have been put back in.
- It takes about 70 minutes to charge the earbuds with the case.
Playback
Play/Pause: Double tap
Answer / Hang up: Double tap
Phone Calls
Decline: Tap and hold for 2S
Activate voice control of Mobile Phone: Double tap (Bluetooth on and not in a
call)
Extra Functions
- Gaming Mode can be switched via the omthing APP.
- Multiple EQs are available on the omthing APP, including 6 preset EQs and 2 custom EQs. EQ switching is only available in Stereo Mode.
- Clear The Pairing Records: Take out the earbud(s) and ensure disconnection to any device, tap on the Touch Control Area of either the Left or Right earbud for 6 seconds in Mono or Stereo Mode, the pairing records will then be cleared, the earbud(s) will then turn off after the LED flashes blue for 1 second.
- OTA Firmware Update: It can be synchronously upgraded via the omthing APP while the Left and Right earbuds are connected to each other with at least 50% battery.
- Functions of the omthing APP may vary with different devices or operating systems. For more details, please contact our customer service.
Safety Information
- Never disassemble the headphones. There are no user-serviceable parts inside.
- Do not expose the headphones to temperatures below 32 °F (0 °C) or to temperatures above 113 °F (45 °C).
- Do not use the headphones in a thunderstorm storm. This could prevent the headphones from working properly, and also increase your chance of being electrically shocked.
- Do not use oil or any volatile liquid to clean this product.
- Do not listen at high volumes for extended periods of time.
- Do not use the headphones in traffic. Do not use the headphones any time it would be dangerous to be unaware of noises around you.
- Adult supervision is required for children of age 6 and under.
- If you don’t feel comfortable after wearing the headphones, please refer to an aurist for advice on whether in-ear headphones are suitable for you.
Tips
- Please read this instruction manual carefully and retain for future reference.
- Please fully charge the battery before first use.
- If the headphones have been unused for more than 3 months, we recommend that you charge them. This will improve battery capacity.
- Only use chargers that are FCC (Federal Communications Commission) approved.
- In dry environments, static electricity may numb your ear. This is not related to the quality of the product.
FCC
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.
Device types EO009 has also been tested against this SAR limit.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
IC
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and(2) this device must accept any interference, including
interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
This device has been tested for compliance with IC SAR values at a typical
operating near the body.
To ensure that RF exposure levels below the levels tested, use accessories
with this equipment to maintain a minimum separation distance of 0 cm between
the body of the user and the device.
These accessories should not contain metallic components. It is possible that
the accessories used close to the body that do not meet these requirements are
not consistent with the SAR limits and it is advisable to avoid using them.
WEEE
All products bearing this symbol are waste electrical and electronic equipment
(WEEE as in directive 2012/19/EU) which should not be mixed with unsorted
household waste. Instead, you should protect human health and the environment
by handing over your waste equipment to a designated collection point for the
recycling of waste electrical and electronic equipment, appointed by the
government or local authorities. Correct disposal and recycling will help
prevent potential negative consequences to the environment and human health.
Please contact the installer or local authorities for more information about
the location as well as terms and conditions of such collection points. Your
omthing retailer will advise you of the correct way of disposal in your
country.
Safety Caution
Do not expose batteries or battery packs to excessive heat such as sunshine,
fire or the like.
Tiinlab Corporation hereby declares that this product is in compliance
with the essential requirements and other relevant provisions of Directive
2014/53/EU and all other applicable EU directive requirements.The full text of
the EU declaration of conformity is available at the following internet
address:www.1more.com
Hereby, Tiinlab Corporation declares that the radio equipment type EO009
is in compliance with Radio Equipment Regulations 2017. The full text of the
UKCA declaration ofconformity is available at the following internet address:
www.omthing.com
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc.
The Qi logo is a registered trademark of the Wireless Power Consortium.
Warning
Replacement of a battery with an incorrect type that can defeat a safeguard
(such as catching fire, explosion, leakage of corrosive electrolyte etc);
Disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, that can result in an explosion;
Leaving a battery in an extremely high temperature surrounding environment
that can result in an explosion or the leakage of flammable liquid or gas; and
A battery subjected to extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas.
**** The symbol indicates DC voltage.
FAQ
1. Why the headphones cannot be turned on?****
– Check if your headphones have enough battery life. If not, please charge them for at least 30 minutes.
2. Why the headphones cannot connect to my cellphone, or take a long time to connect?****
– 1) If the connection times out, you can put the left and right ears into the
case, re-enter the pairing state with the device, and then click “omthing
AirFree Buds” in the Pairing list of Bluetooth devices to connect.
– 2) To connect to a new device, turn off the Bluetooth connection on the
original connected device.
– Make the headset enter the pairing state, and click “omthing AirFree Buds”
in the new device pairing list to connect.
3. Why the headphones cannot play music after successfully connecting to my Android device?****
– After pairing successfully, on the Bluetooth menu of your device, tap the icon on the right of your device name and make sure the “Media Audio” option is on.
4. Why there is no sound from the headphones while making phone calls after successfully connecting to my Android device?****
– After pairing successfully, on the Bluetooth menu of your device, tap the icon on the right of your device name and make sure the “Phone Audio” option is on.
5. Why the Bluetooth connection is not stable and causes some interruptions?****
– 1) Try shortening the distance between your headphones and device. Avoid
solid barriers in between.
– 2) Please keep away from strong interference sources, such as Wi-Fi and
GPRS.
– 3) Please make sure the Bluetooth antenna of your device is not blocked.
6. Why some control functions do not match those in the manual while using third party music/video player Ap ps?
– Your operating system and the third party music/video player apps may have different settings for the control functions. We recommend that you use the music/video player apps that your device has originally provided.
Name: Wireless Earphones
Model: EO009
Single Earbud Weight: 4 g
Case Weight: 33 g
Gross Weight: 41 g
Earbuds Size: 24.4 x 23.4 x 15.6 mm
Case Size: 65 x 27.3 x 42.2 mm
Earbud Battery Capacity: 37 mAh
Case Battery Capacity: 500 mAh
Earbuds Charging Time: 70 mins
Case Charging Time : 165 mins
Earbud Playtime: 7 hours
Earbuds + Case Playtime: 44 hours
Speaker Impedance: 30 Ω
Bluetooth Range: 10 m
Bluetooth Version: Bluetooth® 5.3
Input: 5V **** 300mA
Working Temperature: 0℃- 45℃
Bluetooth Protocol: HFP / A2DP / AVRCP
Frequency Band: 2.400GHz – 2.4835GHz
- The specifications are acquired from laboratory tested data.
- The playback time, tested under the laboratory condition of AAC format and 50% volume, may vary with different device setting, environments, usage and other factors.
FCC ID: 2ASDIEO009
IC: 24662-EO009
omthing APP
For users outside mainland China, please downloadthe omthing APP for product upgrades and additional features. - APP Ul in user guide may vary and for reference only, please refer to Ul on device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>