Waterpik XRO-763 High Pressure Powerpulse Massage Instruction Manual
- June 9, 2024
- Waterpik
Table of Contents
Waterpik XRO-763 High Pressure Powerpulse Massage
To begin your Waterpik® shower experience we want to give you all of the
proper information to make installation easy and quick. This way you are that
much closer to enjoying an invigorating shower with your new showerhead. You
can access more products and information on your product at
www.waterpik.com.
Note: Pictures shown may not directly match your shower head.
PRIOR TO INSTALLATION
- Write down your model number in the allotted space above. (The model number is found on the packaging near the barcode.) If you do not have the package you may find the model number on our website www.waterpik.com.
- Remove the old shower head and remove all pipe tape as well.
- Ensure that the washer from the old shower is not connected to the pipe. Use a thin utensil to check inside the pipe for washers, such as a pencil or screwdriver. Do not use your fingers.
- Gather the tools necessary to install your new shower head.
INSTALLATION
-
Type A or B Bracket:
Tighten the pivot ball to the pipe. Ensure the large nut is secure by hand tightening. -
Type A or B Bracket:
If your hose has a ridged connector, connect the ridged connector to the bracket and hand tighten. (See note below). -
Type A: Connect another end of the hose to the handheld shower head and hand tighten.
Type B: Connect the other end with the rubber ring to the hand-held shower head and hand-tighten. -
Place the hand-held shower head in a bracket.
Type C Bracket:
- Tighten the hex nut to pipe using the necessary tools. Do not over-tighten.
- Connect the ridged end of the hose to the bracket and hand tighten.
- Connect the other end with the rubber ring to the hand-held shower head and hand-tighten.
- Place the handheld shower in the bracket.
- Rotate the bracket forward or back to adjust the spray angle.
Note: Several U.S. state and local municipal plumbing codes require the use of a backflow prevention device when installing a hand shower. This device is termed a vacuum breaker. If your hand shower includes a vacuum breaker it will be located in the hose, and the hose end with the vacuum breaker will include a sticker that reads “attach this vacuum breaker end to shower bracket.” If the hose is not installed in this manner, water will not flow. If your hand shower does not include a vacuum breaker, and you would like to obtain one free of charge, please contact us at 1-800-525-2774 (U.S. calls only) and request part number 20009558.
OPERATION
- Spray Selector: Spray Selector allows you to select from various spray patterns. On some models, the spray pattern is controlled by the small lever that rotates left and right. Some models do not have a small lever. Rotate the trim ring around the face of the shower head to change the settings.
- EasySelect® Spray Selector (some models): On some models, spray pattern is controlled by a rotating ring on the handle. Rotate the selector in either direction to control the pattern.
SPECIAL FEATURES FOR SELECT MODELS
-
Water-Saving Trickle Setting (some models): To use the water-saving trickle, simply push the toggle switch on the back of the shower head. This will reduce water flow to approximately 0.5 gallons per minute. To return to the original setting, push the toggle on another side of the shower head.
-
Pause in Handle (Some Models): Some models have a water-saving flow control that allows you to control water flow from full power to a water-saving trickle. This flow control is located on the handle.
Note: This pause button will not shut off the water flow completely. A small amount of Sliding Switch Push Buttons for continuous water flow is necessary to meet plumbing code requirements. The ASME A112.18.1 standard is the official regulation used by the U.S. Dept. of Energy and plumbing code and states that a flow control device shall not completely shut off the flow of water downstream of the primary shut-off valve when fitted to, or integral with, a shower head or hand-held shower. -
Hybrid Power Dial (some models): Move the dial left and right to customize any spray setting. Select from full power to eco power to conserve water.
-
Extension Clip (some models): If following installation, the position of the shower head is too high, you may install the included extension clip.
Slide the clip onto the shower head from
the side. Rotate the clip 90 degrees so that it extends off the rear of the
shower head. Slide the clip into the bracket.
WARNINGS
- To avoid hot water dangers and conserve even more energy, make sure your water heater is set at 120°F (48.9°C) or below.
- Test the tub/shower water with your hand before bathing.
- For additional safety for Ecoflow® or high-efficiency shower heads, it is recommended that all homes have installed a pressure balance tub and shower valve with the rotational limit stops properly set by a plumber. If you are unsure of your valve type consult your plumber.
- For external use only. The potentially deadly amoeba, Naegleria fowleri, may be present in some tap water or unchlorinated well water.
- Always ensure the handheld shower head is properly placed in the bracket, so as to prevent the shower head from falling.
- Do not pull on or tug the flexible hose. This may result in the shower head coming loose and falling.
CARE AND CLEANING
- To maintain proper working conditions cleaning is required when mineral deposits appear on the spray orifices. To clean mineral deposits, gently rub the rubber nozzles on the face of the shower head to dislodge them.
- To clean heavier deposits, remove the shower head and soak face down in 1-2 cups of white vinegar (use white vinegar only) for about 2-3 hours. Replace the shower head and run in each mode to flush out the vinegar. Repeat as necessary.
- Do not clean or rinse any part with harsh chemicals, heavy-duty cleaners, or abrasives; this may damage parts or finish and will void the warranty.
- Clean the filter screen by unscrewing from the pivot ball and rinse by back flushing to remove particles. Follow steps 1-3 under installation to the reinstall shower head, making sure the washer is re-seated on top of the filter screen.
TROUBLESHOOTING GUIDE
LIMITED LIFETIME WARRANTY
Save your receipt as proof of purchase is required for warranty action. Water
Pik, Inc. warrants to the original purchaser of this
the product that it is free from defects in material and workmanship for as
long as the original purchaser owns this product. Water Pik, Inc. will replace
any part of the product which in our opinion is defective, provided that the
product has not been abused, misused, altered or damaged after purchase. (This
includes damage due to the use of tools or harsh chemicals.) In the event an
item has been discontinued we will replace it with what we deem to be the
closest product. Water Pik, Inc. is not responsible for labor charges,
installation, or other consequential costs. The responsibility of Water Pik,
Inc. shall not exceed the original purchase price of the product. This
warranty gives you specific legal rights. You may also have other rights that
vary where you reside.
Have any questions or need assistance?
For quick service prior to calling have your model number and receipt ready.
In the U.S., call our toll-free Customer Assistance Line at
1-800-525-2774. In Canada, call our
toll-free Customer Assistance Line at
1-888-226-3042.
www.waterpik.com Outside the U.S., write us at
Water Pik, Inc. 1730 East Prospect Road Fort Collins, CO 80553-0001 U.S.A If
product malfunctions or becomes damaged, stop use and contact Water Pik, Inc.
for replacement.
Waterpik® is a trademark of Water Pik, Inc. registered in Argentina, Australia, Austria, Benelux, Canada, Chile, China, Czech Republic, EU, Finland, France, Germany, Hong Kong, Hungary, India, Israel, Italy, Japan, Kazakhstan, Korea, Mexico, Norway, Poland, Russian Federation, South Africa, Spain, Sweden, Switzerland, Taiwan, Turkey, Ukraine, and the United States.
Waterpik® (stylized) is a trademark of Water Pik, Inc. registered in Australia, Canada, China, EU, Hong Kong, India, Israel, Japan, Korea, Mexico, Russian Federation, Switzerland, Taiwan and the United States. EcoFlow® is a trademark of Water Pik, Inc. registered in Australia, Canada, China, EU, Hong Kong, Mexico, and the United States. Optiflow® is a trademark of Water Pik, Inc. registered in Australia, Canada, China, EU, Hong Kong, India, Japan, Korea, Mexico, Taiwan, and the United States. EasySelect® is a trademark of Water Pik, Inc. registered in Australia, Canada, China, EU, Mexico, Taiwan and the United States. Shower Massage® is a trademark of Water Pik, Inc. registered in Canada. The Original Shower Massage® is a trademark of Water Pik, Inc. registered in the United States. Treat Yourself Better® is a trademark of Water Pik, Inc. registered in the United States. The Plus is in the Power® is a trademark of Water Pik, Inc. registered in Canada, Mexico and the United States. A Powerful and Invigorating Experience® is a trademark of Water Pik, Inc. registered in Canada, Mexico and the United States. © 2017 Water Pik, Inc. Printed in China.
FAQs
My shower head leaks. What should I do?****
If you are experiencing a leak, please check to make sure the hose is connected to the handheld shower head. If it is, please check to see if there is any pipe tape on the threads of the handheld shower head. If there is, remove it and try again.
My shower head will not stay in place. What should I do?****
Please check to make sure that your handheld shower head is not connected to the hose with a ridged connector. The ridged connector will not work with this model. If it is connected with a ridged connector, please remove the ridged connector and connect the hose directly to the handheld shower head.
My handheld shower head does not spray water out of all of its nozzles. What should I do?****
Please check to make sure that you are using the correct setting for your desired spray pattern on your handheld shower head. You can find more information on how to use your handheld shower head in the manual included with your product or online at www.waterpik.com/manuals/handheldshowerheads/.
How long is hose on Waterpik PowerPulse?****
Chrome, 2.5 GPM, 2-in-1 Dual System, 5-foot hose, PowerPulse Therapeutic Massage, Waterpik High Pressure Shower Head Handheld Spray, XET-633-643
What angle do you use a Waterpik?****
Aim the tip at the gumline at a 90-degree angle, starting with the back teeth and moving forward along the gumline after a brief pause between the teeth. To let the water flow to eliminate plaque and debris, hold the tip just slightly away from the gums.
What is the best setting for a Waterpik?****
Every new user should begin on low so they can become used to the device. They should comfortably raise the pressure until it reaches the 6 or 7 level on the countertop or the 60 or 75 setting on a handheld in order to achieve the best results. You can use the Water Flosser at settings 8, 9, or 10.
Do You Use warm or cold water for Waterpik?****
Place a tip into the handle after adding warm water to the reservoir. 2. Put the tip in your mouth while leaning over the sink.
What is the best pressure for WaterPik?****
You must use a minimum of 70 PSI to remove 99.9% of the plaque. As a result, the dial must be set to 7 or higher. You might feel uncomfortable with a high pressure when using a Waterpik for the first time. If so, I advise starting at a lower pressure and increasing it gradually.
What time of day should you use a WaterPik?****
You must use a minimum of 70 PSI to remove 99.9% of the plaque. As a result, the dial must be set to 7 or higher. You might feel uncomfortable with a high pressure when using a Waterpik for the first time. If so, I advise starting at a lower pressure and increasing it gradually.
Do you need to brush if you use a Waterpik?****
Regular flossing and using a toothbrush are still necessary. You should still use a water flosser before or after brushing your teeth twice a day. Put the flosser tip in your mouth after filling the water reservoir of your water flosser with warm water.
Video
Download PDF Link;Waterpik High Pressure Powerpulse Massage pdf
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>