smeg MFF01BLEU Milk Frother Black User Manual

MFF01BLEU Milk Frother Black
User Manual

MFF01BLEU Milk Frother Black

We advise you to read this manual carefully, as it contains all the instructions for managing they appliance’s aesthetic and functional qualities.
For further information on the product: www.smeg.com

Dear Customer,
Thank you very much for purchasing the Smeg Line Milk Frother.
By choosing our product, you have opted for a solution in which aesthetics and innovative technical design offer unique objects, which become part of the furnishings.
In fact, a Smeg household appliance always co-ordinates perfectly with other products in the range and, at the same time, can become a design object for the kitchen.
We hope you fully appreciate the functionalities of your appliance. Best regards.
SMEG S.p.A.

Precautionary measures

SAFETY
Basic safety rules.
The device runs on electricity, so the following measures must be observed precautions:

• Do not touch the electrical plug wet hands.

• Make sure that the one you are using is electrical outlet has always been access to disconnect the plug from it in if necessary.

• Never pull on the cord to avoid his damage.

• In the event of a device malfunction don’t try to fix it on one’s own. Turn off the device, remove plug from the socket and turn to service department.

• If the plug or power cord damaged, they must be replaced performed only in service centers to avoid any risk.

• Do not immerse the device in water.

• Attention! Before cleaning you need to remove the plug from the socket.

• Do not let the power cord hang from edges of a table or other surface, and to touch hot objects.

• Packaging materials (plastic bags, expanded polystyrene) should be stored in a place inaccessible to children.

• Do not allow to use appliance of people (including children) with limited psycho physical or sensory abilities or not with sufficient experience and knowledge without strict supervision and guidance by the person responsible for their safety. Don’t let the kids play with the device.

• Do not place the device above electric or gas stoves or next to them, as well as inside heated oven or oven.

• Check that there are no there were foreign objects.

• Do not overfill the jug, always observe the level indicated by the marks, engraved on the inside surface of the jug.
  Filling the container above the specified limit level can be hazardous if splashed out her frothed milk.

• The jug gets hot during operation. Do not touch hot surfaces. You should always take special the handle with which the jug is equipped.

• Persons with pacemakers or similar devices should make sure they work devices have not been violated by induction electric field with frequency range from 20 to 50 Hz.

• The beater disc can be a source of risk of suffocation from a foreign body. Should keep it out of the reach of children.

Connecting the device
Make sure that the mains voltage corresponded to that indicated on the factory label on the bottom of the instrument.
The device must only be connected to properly installed electrical socket with a minimum current of 10 A and with effective grounding.
If the socket and plug of the appliance incompatible, please contact service department to replace them.

For European markets only:

• Children aged 8 and over allowed to use data appliance only if they are supervised or trained safe use of the device and understand the risks involved.
• Cleaning and care can be performed children aged 8 years and over adult supervision.
• Keep the appliance and power cord in place inaccessible to children under 8 years of age.
• Children are not allowed to play with the appliance.
• Before performing any operations assembly, disassembly and cleaning should be disconnect the device from the network.

Intended use
This appliance is designed to heat and frothing milk, as well as for making hot chocolate. Not use the appliance for purposes other than from those for whom it is intended.
The appliance is intended only for home use.
Manufacturer’s responsibility
The manufacturer disclaims all liability for damage to people and property caused by:

• use of the device for purposes other than those provided;
• failure to read the manual for operation;
• integrity violations even only one of the parts of the device;
• use of non-original spare parts;
• non-compliance with safety rules.

This should be carefully stored management. If the device is transferred to other persons, also give them this manual.

DISPOSAL
Electrical appliances must not be disposed of with household waste.

Devices with this symbol fall under under EU Directive 2012/19/EU. All obsolete electrical and electronic devices must disposed of separately from household waste and be transferred to the appropriate recycling centers provided state. Proper Disposal obsolete device necessary to prevent damage environment and health risks of people. For more detailed information about the disposal of the released use of the appliance, please contact to the local administration, to the department for waste disposal or to the shop where you have been device purchased.

 Description/Assembly

DESCRIPTION OF THE INSTRUMENT (Fig.1)

1. base with motor

2. Jug

3. Notched whisk (for whipping milk or chocolate)
   3a Smooth whisk (for keep warm function) milk)

4. Lid

5. Measuring cap

6. START/STOP button

7. Program selector knob

8. Light-emitting diode

IDENTIFICATION PLATE
On the identification plate technical data, factory number and label. By no means remove identification plate.
BEFORE THE FIRST IN USE (Fig.1)

• Carefully remove the packaging from the device and remove all packaging materials and remnants of labels and stickers.
• Clean base with motor (1) damp cloth. Wash and dry thoroughly all components (see “Cleaning and Maintenance”).

 Check before use integrity of all components.

ASSEMBLING COMPONENTS (Fig. 1)

• Place the jug (2) on the base with engine (1).
• Insert the whisk (3) inside the pitcher (2) and place it on the special pin.
• Place the lid (4) on the jug (2) and click down on it.

DEVICE DESCRIPTION CONTROLS (Fig. 1)
Program selector knob (7)
The device has 6 preset set programs and manual mode, which are switched using the handle (7).

Liquid level gauges

(including the amount chocolate).
| Max Level filling with milk whipping.
| Minimum level.

Usage

OPERATION (Fig. 1)
Recommendations for use instrument
Result of whipping function milk may depend on ingredients used. To get a good result recommended use whole milk, taking it out refrigerator directly before pouring into a jug (2).
After the first heating cycle wait for the device cool down before starting another cycle.
Do not start the device without liquid. Starting the instrument without fluids can lead to jug damage.
Should always be filled to the MIN level and never exceed the MAX level. Both levels are indicated inside the jug.
  If the LED on the handle flashes and three sounds are repeated twice signal, This means What V work instrument arose error. State mistakes signalled if jug or whisk missing jug is removed during cooking or starting work cycle with an empty jug. In the first two cases, the cycle is not starts, while in two the last cycle is started, but stops after a few seconds.

• Insert the plug into the socket.
• LED (8) starts flashing. Approximately through 120 seconds inaction device passes V mode expectations And Light-emitting diode turns off.

Heating or frothing milk

• Remove the lid (4) and pour cold milk into a jug (2), keeping an eye on the level by marks engraved on the inside of the jug.

• Replace the cover (4).

• Select the desired program by turning handle (7) before level red labels on ring pens.
  The device will switch from the mode standby mode.

• Press the START / STOP button (6) to start of the cycle, while the LED (8) will light up and stay on without blinking.

• Beep and LED off (8) point out What cycle ended.

• The cycle can be stopped before the set time by pressing the START / STOP button (6).

• Remove the cover (4) by grasping it at the side you ribs.

• Remove the jug (2) and pour in the frothed milk, helping yourself with a spoon.

Adding sugar or sweets syrups (such as honey, juice agaves or maple syrup, etc. etc.) it is recommended to produce at the end of the cycle.
Chocolate making

• Remove the lid (4) and place in a jug (2) chocolate ingredients, following level according to the marks engraved on the inside of the jug, and guided by the recommendations contained in the Smeg recipe.
• Select the appropriate program And act Tokay, How described for milk.
  Can be removed while working measuring cap (5) for adding any powdered ingredients. It is recommended to add them slowly And small quantities through some seconds after start cycle, to give milk warm up. The addition made too fast or excessive amounts may stop rotation corolla or to its displacement in wrong position.

Manual mode

• Remove the lid (4) and pour milk into the jug (2), keeping an eye on the level marks engraved on the inside side pitcher.
• Replace cover (4).

You can choose hot or cold foaming.
Hot foaming in manual mode:

• To start manual mode (M) with heating function press the button START / STOP, LED (8) lights up and will burn without blinking. Whisk speed and the temperature is rising proportional to duration cycle. User Maybe interrupt cycle, clicking button START / stop, How only consider that the degree readiness is sufficient.

Cold frothing in manual mode:

• When you press and hold the button START / STOP for approx. 3 seconds whisk starts beating milk without heating it, while LED (8) continues to flash for throughout the duration cycle. The user can interrupt cycle by pressing the START/STOP button as only considers that the degree is ready- ness is sufficient.
  • In both cases, after a certain time Job V manual mode break off automatically For ensure security and product functionality.
  • Beep and shutdown LEDs (8) indicate what a cycle ended.
  • The next step is to act as described for milk.
  Can be removed while working measuring cap (5) and add any powdered ingredients (For example, soluble coffee, instant cappuccino, instant tea, etc.).

 Cleaning and maintenance

CLEANING AND TECHNICAL MAINTENANCE (Fig. 1)
Before cleaning must ALWAYS be removed plug from an electrical outlet and let the appliance cool down. Never submerge the base With engine (1) water or other liquids.
The instruction manual contains proper cleaning instructions and maintenance, and See also manufacturer’s recommendations. client. Any other operations must be carried out by an authorized service representative.

• Remove whisk (3).
• Remove the jug (2) from the motor base.
• Whisk (3), lid (4), measuring cap (5) and jug (2) can be washed in the dishwasher car.
• Base with motor (1) can be clean first with a damp cloth and then dry cloth. Do not use detergents funds or abrasive materials.

Recipes

HOT CHOCOLATE
Quantity for two cups
Ingredients

• Whole milk: 250 ml

• Black chocolate, shavings: 90 years

Cooking

• Pour milk into a jug.
• Add chocolate chips.
• Close the lid.
• Select a cooking program hot chocolate ( ).
• Press the START / STOP button and wait for the program to finish.

CAPPUCCINO
Quantity for two cups
Ingredients

• Whole milk: 200 ml
• Coffee: 80 ml
  strong coffee: 40 ml

Cooking

• Prepare coffee using the coffee machine and pour him in cup.
• Pour milk into the frothier jug.
• Close the lid.
• Select a cooking program hot milk With thick foam ( ).
• Press the START/STOP button and wait for the completion programs.
• Pour milk foam over coffee.
• Add optional teaspoon sugar or sweet syrup.

ESPRESSO WITH ICE
Quantity for two cups
Ingredients

• Whole milk: 200 ml
• Coffee: 80 ml
• Ice cubes: 4 ml

Cooking

• Place ice cubes in 2 glasses.
• Make coffee with the coffee machine And pour out his on ice glasses.
• Add a teaspoon if desired sugar or sweet syrup.
• Pour milk into a frothing jug la.
• Close the lid.
• Select a cooking program cold milk with thick or with light foam optional (  / ).
• Press the START/STOP button and wait for the completion programs.
• Pour milk foam into glasses with coffee and ice.

What To Do If…..

the plug into the socket.
Device stops during working hours.| The jug is empty.| Fill jug.
The pitcher was removed during cooking time.| Set the pitcher in corresponding socket.
Ingredients too thick or too large e.g. chocolate chips large size.| Use less large ingredients.
The work cycle is not starts.| Jug missing.| Set the pitcher in corresponding socket.
The whisk is missing.| Check to whisk was in place and installed Right.
The milk does not froth.| The milk is not cold.| Use cold milk.
The pitcher contains water residues or is dirty.| Make sure that the pitcher is dry and clean.
The whisk used is not correct.| Mount the notched whisk.
Use of milk already frothed or heated.| Do not use milk already frothed or heated.
Use of low-fat milk.| Use suitable milk.
The ingredients do not
melt.| Ingredients too thick or excessive amount introduced.| Chop the ingredients before introducing them or check preparation suggestions.

If the problem has not been solved or there are other types of malfunctions, should contact the service department place location.
Producer
Smeg SpA Via Leonardo da Vinci 4,
Guastalla, 42016, Italy
Place of production
Sandora Naushold Without Electrical Appliances
(Shenzhen), China China, Shenzhen,
Bao’an District, Tongfuyu Industrial Park, st.
Shaijing

The manufacturer reserves the right to make any changes deemed useful for improvement of its products without prior
notice. The illustrations and descriptions contained in this manual are therefore not binding and are merely indicative.

References

• Smeg - Technology with style | Smeg.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>