V-TAC MAX RATED LOAD Surface Spotlight Fitting Instruction Manual
- June 4, 2024
- V TAC
Table of Contents
WEEE Number:80133970
INSTALLATION INSTRUCTION
SURFACE SPOTLIGHT FITTING
TECHNICAL DATA:
| MODEL | VT-978 | VT-979 |
|---|---|---|
| MAX RATED LOAD | 35W | 35W |
| BASE | GU10 | GU10 |
| DIMENSION | Ø98x118mm | 100x100x120mm |
| SHAPE | ROUND | SQUARE |
| INPUT POWER | AC: 220-240V, 50Hz |
*3 YEARS WARRANTY**
INTRODUCTION & WARRANTY
Thank you for selecting and buying the V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at their best. The warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours of Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.
WARNING!
-
Please make sure to turn off the power before starting the installation.
-
Installation should only be done by a certified electrician.
-
Before drilling the mounting holes, please make sure there is no gas, water, or electrical pipelines.
-
Do not install the light on a damp or conductive subsurface.
The Ingress protection rating of the fixture is IP20. -
For indoor use only. ****
This marking indicates that this product should not be disposed of with other
household wastes.
Caution, risk of electric shock.
WIRING DIAGRAM:
N – Black / Blue Wire
L – Brown / Red Wire
INSTALLATION DIAGRAM:
INSTALLATION DIAGRAM:
- Switch off the power before starting the installation
- Drill mounting holes on the ceiling put the rubber plug in the hole and fix the bracket on the ceiling with a screw solidly.
- Connect the wire as per the wiring diagram.
- Install the lamp body into the bracket and tighten the screw safely and solidly.
- Install the lamp(GU10) into the lamp holder.
- Switch on the power to test the light.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>