ENFORCER DE-S104Q High Speed USB 2.0 1×4 Extender Instruction Manual

ENFORCER DE-S104Q High Speed USB 2.0 1×4 Extender

INTRODUCTION

The ENFORCER High-Speed USB 2.0 1×4 Extender creates a one-to-one connection through CAT5e/6/7 network cables, transmitting signals up to 492′ (150m). It supports four (4) High-Speed USB 2.0 ports and is compatible with most USB 2.0 devices making it a good choice for office, security, audio/video, and medical facilities.

• Supports four (4) High-Speed USB 2.0 inputs and one (1) High-Speed USB 2.0 output
• Compatible with Cat5e/6/7 network cables
• Transmission range up to 492′ (150m) with Cat6/7 cable
• Plug and Play
• Extend transmission further with Gigabit switch support
• Hot-Plug USB (auto-detects USB type — High-Speed, Full-Speed, and Low-Speed)

Parts List

• 1x Transmitter
• 1x Receiver
• 1x USB Cable
• 1x Power supply
• 1x Manual

Specifications

Overview

Installation

1. Connect the USB cable to the transmitter and the device you desire a USB extension for.
2. Connect the network cable (CAT5e/6/6A/7) to the transmitter and receiver.
3. Plug the power supply into the receiver.

The four (4) ports on the receiver are now operational and ready for use.

Wiring Diagram

One-to-one connection

Switch relay connection

Troubleshooting

• No response when the device is connected.
  • Check that the USB drivers are properly installed and updated.
  • Check that the network cable is properly connected.
  • Reset the receiver by pushing the Reset button
• The receiver is unstable when connected to an external web camera
  • High-powered USB devices require an external power source.

FCC COMPLIANCE STATEMENT

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

• Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

• IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna
  or the device could result in the device exceeding the RF exposure requirements and void the user’s authority to operate the device.

• IMPORTANT: Users and installers of this product are responsible for ensuring that the installation and configuration of this product comply with all national, state, and local laws and codes. SECO-LARM will not be held responsible for the use of this product in violation of any current laws or codes.

• California Proposition 65 Warning: These products may contain chemicals that are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

WARRANTY

This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for one (1) year from the date of sale
to the original customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to
SECO-LARM. This Warranty is void if the damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration, improper
or abnormal usage, or faulty installation, or if for any other reason, SECO- LARM determines that such equipment is not operating properly as a result of causes other
than defects in material and workmanship. The sole obligation of SECO-LARM and the purchaser’s exclusive remedy shall be limited to the replacement or repair
only, at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damage of any
kind to the purchaser or anyone else.

NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without
notice. SECO-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2022
SECO-LARM U.S.A., Inc. All rights reserved.

16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco- larm.com
Phone: 949-261-2999 | 800-662-0800 Email: sales@seco- larm.com

References

• La Armería de Madrid - fabricantes de armas y rifles
• P65Warnings.ca.gov

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>