TIMEGUARD LEDBHR7W LED Energy Saver Bulkhead Light Instruction Manual

: June 9, 2024
: TIMEGUARD

Table of Contents

General Information
Safety
Technical Specifications
Installation
Connection
Operation
3 Year Guarantee
HELPLINE
TIMEGUARD
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TIMEGUARD LEDBHR7W LED Energy Saver Bulkhead Light Instruction Manual

General Information

These instructions should be read carefully and retained for further reference and maintenance.

Safety

Before installation or maintenance, ensure the mains supply to the luminaire
is switched off and the circuit supply fuses are removed or the circuit breaker turned off.
It is recommended that a qualified electrician is consulted or used for the installation of this luminaire and install in accordance with the current IEE wiring and Building Regulations.
Check that the total load on the circuit including when this luminaire is fitted does not exceed the rating of the circuit cable, fuse or circuit breaker.

Technical Specifications

230V AC 50 Hz
This luminaire is of class I construction and must be earthed
LED non replaceable lamp
Colour Temperature: 5000K
IP65 Rated suitable for restricted external applications
UKCA & CE Approved

Mode	Watts	Lumen Mounting	Output Hole Centres	Dimensions
LEDBHR7W	7W	700lm	88mm	Ø153 D:59
LEDBHR15W	15W	1000lm	126mm	Ø185 D:65
LEDBHR25W	25W	2000lm	155mm	Ø244 D:75
LEDBHO9WN	7W	700lm	124mm	H:155 W:100 D:52
LEDBHO15W	15W	1000lm	176mm	H:215 W:131 D:69
LEDBHO25W	25W	2000lm	220lm	H:270 W:165 D:86

Installation

Remove the front of the unit by undoing the 4 bolts remove the bezel and lens with gasket.
Mark the position of the mounting holes on the wall using the unit as a template.
Drill the holes for the wall plugs ensuring not to infringe with any gas/water pipes or electrical cables that may be hidden below the surface.
Undo the cable gland sufficiently to allow the cable to be pushed through the back.
Secure the supply cable into the luminaire through the hole(s) provided ensuring that a cable gland, grommet or sealing compound is used to maintain the IP rating of the luminaire.
Leave enough slack to allow for wiring, re-tighten the cable gland.
Fix the luminaire using the correct screws for the wall plugs installed.
Terminate the cable into the terminal block (see section 5 connection diagram) ensuring correct polarity is observed and that all bare conductors are sleeved.
Secure the supply cable using the cable clamp.
Reposition the lens over the unit, taking care to ensure the gasket is in place.
Secure the lens and bezel back into place using the 4 bolts previously removed at the beginning of the installation.

Connection

Connecting Instruction

Live (Brown or Red): L
Neutral (Blue or Black): N
Earth (Green/Yellow):

Operation

Turn the power and the unit will illuminate.

3 Year Guarantee

In the unlikely event of this product becoming faulty due to defective material or
manufacture within 3 years of the date of purchase, please return it to your supplier in the first year with proof of purchase and it will be replaced free of charge. For years 2 and 3 or any difficulty in the first year, telephone the helpline on 020 8450 0515.

Note:
A proof of purchase is required in all cases. For all eligible replacements (where agreed by Timeguard) the customer is responsible for all shipping/postage charges outside of the UK.All shipping costs are to be paid in advance before a replacement is sent.

If you experience problems, do not immediately return the unit to the store. Telephone the Timeguard Customer Helpline;