ELKRON IT3000-4G LTE-4G Interface for MP3000 Control Panels Instruction Manual
- June 9, 2024
- ELKRON
Table of Contents
ELKRON IT3000-4G LTE-4G Interface for MP3000 Control Panels
LEGEND
LEGEND
A
| | ● Connettore SMA per antenna ● SMA antenna connector
● Connecteur SMA pour l’antenne ● SMA-Verbinder für Antenne
B
| ****
REG
| ● LED stato di connessione alla rete telefonica mobile. Acceso : ricerca rete, chiamata connessa Lampeggiante : Interfaccia registrata alla rete, connessione dati
● LED mobile phone network connection status. On : Network search, call connected
Flashing : Registered network interface, data connection
● LED état de connexion réseau de téléphonie mobile. Allumée : recherche réseau, appel connectée Clignotante : Interface enregistrée au réseau, connexion de données
● LED Verbindungsstatus an das Mobiltelefonnetz. Eingeschaltet : Netzsuche, Anruf verbunden Blinkend : : Schnittstelle im Netz registriert, Datenverbindung
●
C
| | ● Alloggiamento per SIM card (formato nano SIM)
● SIM card slot (nano SIM size)
● Logement pour carte SIM (format nano-SIM)
● Fach für SIM Card (Format Nano-SIM)
SIM (nano ●
● CARATTERISTICHE TECNICHE ● TECHNICAL FEATURES ● CARACTERISTIQUES TECHNIQUES ● TECHNISCHE EIGENSCHAFTEN ●
● Tensione nominale di alimentazione ● Nominal supply voltage
● Tension nominale d’alimentation ● Nennversorgungsspannung
| | ****
13,8 V⎓
● Tensione di funzionamento ● Operating voltage
● Tension de fonctionnement ● Betriebsspannung
| | 10 ÷ 14,5 V⎓
● Corrente nominale assorbita ● Rated absorbed current
● Courant absorbé nominal ● Bemessungsstromaufnahme
| ● Stand-by| 24 mA (13,8 V⎓)
● Trasmissione (max)
● Transmission (max)
● Transmission (max)
● Übertragung (max)
| ****
95 mA (13,8 V⎓)
● Potenza di uscita (max) ● Output power (max)
● Puissance de sortie (max) ● Ausgangsleistung (max)
| | 2W /1W
ULTRA FDD: 24 dBm
E-ULTRA FDD: 23 dBm
● Banda di frequenza ● Operating frequency
● Band de fréquence ● Frequenzband
| | LTE-FDD B2/B3/B7/ B8/B20
UMTS-HSPA+ B1/B8 GSM/GPRS/EDGE 900/1800 MHz
● Trasmissione dati LTE CAT 1 ● LTE CAT 1 data transmission
| ● In ricezione fino a ● In reception up to
● En réception jusqu’à ● In Empfang bis
| ****
10 Mbps
● In trasmissione fino a
● In transmission up to
| ****
5 Mbps
● Formato SIM card ● SIM card format
● Format carte SIM ● SIM-Kartenformat ●
| | Nano-SIM
● Dimensioni (L x H) ● Dimensions (L x H)
( ● H) x (L Maße ● H) x (L Dimensions ●
| | 40 x 70 mm
● Classificazione secondo la EN50136-2 ● Classification according to EN50136-2
● Classement selon la EN50136-2 ● Klassifizierung nach EN50136-2
| | SP2-SP4, DP1-DP2
This document contains only essential information about the product. Refer to the manuals of the MP3000 panel for more information.
GENERAL DESCRIPTION
The IT3000-4G is an interface for connecting the MP3000 control panel to 4G (LTE CAT1) communication networks. The interface can play back pre-recorded tele-phone messages, transmit data in LTE mode, recognise DTMF tones, and send and receive text messages. It can also establish communication with a remote alarm receiving station (management unit) using the SIA-IP protocol a data channel. This allows connection to Elkron Cloud for remote management of the control panel. The interface is housed directly on the CPU board of the control panel.
ASSEMBLY 1
IMPORTANT! Insert the interface only when the control panel is not powered (mains and battery disconnected). Place the board in the OPT3 position (recommended) of the CPU by carefully aligning both connectors, applying adequate pressure until they engage. OPT1/OPT2 positions can be used as an alternative.
ANTENNA CONNECTION 2
Place the antenna (included) in the specific location at the top left of the box and connect the SMA connector of the antenna to the SMA connector of the interface.
IMPORTANT: It is recommended to tighten the SMA antenna connector on the interface firmly, but without damaging it. Tightening torques 0.9Nm.
SIM CARD INSERTION
IMPORTANT: Before inserting the SIM card into the 4G module, check that
it is active and without any additional paid options that would use up the
credit unnecessarily.
Insert the SIM card only when the control panel is not powered (mains and
battery disconnected). The SIM card (Nano-SIM format) is simply inserted into
the specific housing Push it in until you hear a slight click.
ACCESSORIES
- ANT 2/4G BM: metal cabinet antenna with SMA-M connector compatible with the IT3000-2G and IT3000-4G modules
- ANT 2/4G HG: high gain antenna, cable length 5 metres with SMA-M connector. Compatible with IT3000-2G and IT3000-4G modules.
EN50136-2 COMPLIANCE
The line control must be enabled with a time not exceeding 25hrs (SP2) or 3
min (SP4) to ensure compliance with EN50136-2 in the configuration of the
interface. DP1 guaranteed with: IT3000-4G primary interface and IT3000-PSTN
alternate interface DP2 guaranteed with: IT3000-4G primary interface and
alternative LAN connection with 30 min periodic test.
SIMPLIFIED EU DECLARATION OF CONFORMITY
The manufacturer, Urmet S.p.A., hereby declares that the wireless device: GSM interface Mod. IT3000-4G complies with Directive 2014/53/EU. The complete text of the EU declaration of conformity is available at the following link: www.elkron.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>