FLUKE 5307002 Module User Guide

Integration guide for Module “5307002 / 0 3024 2172”

1 List of applicable FCC rules. KDB 996369 D03, Section 2.2

FCC Rules and Regulations Part 15, Subpart A
Part 15, Subpart A, Section 31
Part 15, Subpart A, Section 33
Part 15, Subpart A, Section 35

FCC Rules and Regulations Part 15, Subpart C
Part 15, Subpart C, Section 207
Part 15, Subpart C, Section 209
Part 15, Subpart C, Section 255
ANSI C63.10:2013

Part 15.21
Any change or modification of that module not expressly approved by the Fluke could void the user’s authority to operate the equipment.

RSS-Gen, Issue 5 + Amendment 1
RSS-Gen, 6.7
RSS-Gen, 8.8
RSS-Gen, 8.9

RSS-210, Issue 10:
RSS-210, B.6

2 Summarize the specific operational use conditions. KDB 996369 D03,

Section 2.3

Part 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired operation of the device.

For integration it must be ensured the module is used in the same way as it was used during testing.

3 Limited Module Procedures. KDB 996369 D03, Section 2.4

The module approval is a limited module approval and not for sale. The user manual integration instructions are internal confidential manufacturing documents.

4 Trace antenna designs. KDB 996369 D03, Section 2.5

The approval is only valid without changing the antenna design.

5 RF exposure considerations. KDB 996369 D03, Section 2.6

The module has very low level of RF energy which is considered compliant without specific absorption testing or SAR.

6 Antennas. KDB 996369 D03, Section 2.7

The approval is only valid without changing the antenna design.

7 Label and compliance information. KDB 996369 D03, Section 2.8

The device where the component is used must be labeled with “Contains FCC ID: T68-VXP3”, “Contains IC: 6627A-VXP3”.
This labeling is not required if the FCC and IC number of the module is visible from the outside.

8 Information on test modes and additional testing requirements. KDB

996369 D03, Section 2.9

N/A

9 Additional testing, Part 15 Subpart B disclaimer. KDB 996369 D03,

Section 2.10

N/A

The firmware of the device cannot be modified or adjusted by the end user.

Fluke Deutschland GmbH
Niederlassung Ismaning

Freisinger Str. 34
85737 Ismaning
Germany

T +49 89 99616-0
www.pruftechnik.com

Sitz Ismaning I HR Freiburg i. Br. HRB 705 046
GeschaftsfUhrer: Ankush Malhotra, Dr. Edwin Becker, Sigrid Hanna Teich, Jeroen van de Wiel
UStidNr.: DE 811 236 495, WEEE Nr.: 302 025 00

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>