MINN KOTA Micro Remote Compact Wireless Remote Owner’s Manual
- June 9, 2024
- MINN KOTA
Table of Contents
- SAFETY CONSIDERATIONS
- COMPATIBLE WITH BLUETOOTH® ENABLED i-PILOT LINK OR i-PILOT SYSTEMS ONLY
- FEATURES
- SERVICE & MAINTENANCE
- COMPLIANCE STATEMENTS
- PARTS DIAGRAM & PARTS LIST
- RECOMMENDED ACCESSORIES
- MINN KOTA ACCESSORIES
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
MINN KOTA Micro Remote Compact Wireless Remote
SAFETY CONSIDERATIONS
Please thoroughly read the user manual. Follow all instructions and heed all safety and cautionary notices. Use of this product is only permitted for persons that have read and understood these user instructions. Minors may use this product only under adult supervision
WARNING
You are responsible for the safe and prudent operation of your vessel. We have
designed your Minn Kota product to be an accurate and reliable tool that will
enhance boat operation and improve your ability to catch fish. This product
does not relieve you from the responsibility for safe operation of your boat.
You must avoid hazards to navigation and always maintain a permanent watch so
you can respond to situations as they develop. You must always be prepared to
regain manual control of your boat. Learn to operate your Minn Kota product in
an area free from hazards and obstacles.
WARNING
It is recommended to only use Johnson Outdoors approved accessories with your Minn Kota motor, such as this i-Pilot Micro Remote. Using non-approved accessories including to mount or control your motor may cause damage, unexpected motor operation and injury. Be sure to use the product and approved accessories, including remotes, safely and in the manner directed to avoid accidental or unexpected motor operation. Keep all factory installed parts in place including motor and accessory covers, enclosures and guards.
WARNING
When the motor is being controlled by the i-Pilot navigation system, the Controller will continue to perform the last task it was assigned, even when the remote is not powered on. Be sure to know how to power the motor “on” and “off,” and always be alert for unexpected motor movement, such as a turning propeller, even when the remote is powered “off.” Refer to the Owner’s Manual for how to control the motor without the i-Pilot remote and become familiar with it’s features including how to turn it “on” and “off.”
COMPATIBLE WITH BLUETOOTH® ENABLED i-PILOT LINK OR i-PILOT SYSTEMS ONLY
Compatible with Bluetooth® enabled systems.|
Not compatible with non-Bluetooth
enabled systems
FEATURES
Speed Down & Speed Up
Press to decrease or increase motor speed.
Prop On/Off
Pressing this button will turn the Prop on and off.
Steer Left & Steer Right
Press to steer the motor to the left or to the right.
High Speed Bypass
Bypasses the current motor speed to speed 10.
Double press to engage. Single press to disengage.
NOTICE: The remote is waterproof.
NOTICE: If your motor is connected to a Heading Sensor, the Speed Down
(backwards), Speed Up (forward), Steer Right and Steer Left buttons
function change to Jog the boat while in Spot-Lock.
NAVIGATION BUTTONS ⮞
Spot-Lock
Press to enable Spot-Lock. When Spot-Lock is enabled from the Micro Remote,
use either the i-Pilot or i-Pilot Link remote, or the fish finder if you want
to save it.
AutoPilot
Press to enable AutoPilot. The selection between Legacy AutoPilot and Advanced
AutoPilot must be made from either the i-Pilot or i-Pilot Link remote.
NOTICE: Specifications subject to change without notice. This diagram is for reference only and may differ from your actual motor
PAIRING THE MICRO REMOTE TO YOUR CONTROLLER
PAIRING THE MICRO REMOTE TO YOUR CONTROLLER
An i-Pilot controller may pair up to 5 remotes. These five remotes can be a
combination of standard i-Pilot remotes and Micro Remotes.
Any additional remotes can be paired using the following steps. Once the
maximum number of remotes have been paired, the controller will start
replacing the oldest paired remote in memory with the new remote.
a. Power up the trolling motor.
b. Locate the Pair Button at the top of the Control Head.
c. Push and hold the Pair Button down. A consistent tone will be emitted
from the Control Head.
NOTICE: Make sure the remote stays within range of the Control Head
during the pairing process
d. While holding the Pair Button on the Control Head, push and hold the
High Speed Bypass and AutoPilot keys on the remote simultaneously
NOTICE: When the remote is being paired to the i-Pilot Controller, the High Speed Bypass and the AutoPilot buttons need to be held down simultaneously. Make sure to also hold the Pair Button on the Control Head to successfully pair the remote to the controller
e. Once successfully paired, 3 longer beeps will be emitted from the
Control Head and the
remote will be paired.
NOTICE: A remote can be paired to one controller at a time. A controller
can have multiple remotes paired to it.
SERVICE & MAINTENANCE
REPLACING THE BATTERY
TOOLS AND RESOURCES REQUIRED ⮞
- Large Coin
INSTALLATION ⮞
a. Make sure your hands are clean, dry and static free. Temporarily
ground yourself by touching a grounded metal object in order to discharge any
static electricity in your body
CAUTION
Static electricity can cause damage to the circuit board. Discharge any static
electricity by touching a metal object that is grounded before beginning the
remote battery replacement.
b. With the remote upside down, use a large coin to rotate the Battery Cover counterclockwise until either of the Unlock Icons align with the Arrow
c. Remove the Battery Cover and old battery and replace with a new CR2450
coin cell battery. Note the proper polarity of the battery
NOTICE: The replacement battery must be a model CR2450 coin cell type. It is strongly recommended that a high quality battery is used.
SERVICE & MAINTENANCE
d. Ensure the rubber O-ring is properly seated in the underside of the
Battery Cover. Replace battery cover by aligning either of the Unlock icons
with the arrow, and pressing the cover down.
e. Rotate the Battery Cover clockwise using the large coin until the Lock
Icon aligns with the Arrow
FOR FURTHER TROUBLESHOOTING AND REPAIR
We offer several options to help you troubleshoot and/or repair your product. Please read through the options listed below.
Buy Parts Online
You can buy parts on-line directly from our website at
minnkotamotors.com. Orders confirmed by 12 noon
central time will ship same day if in stock. Orders after 12 noon central time
will ship the next business day if in stock.
Frequently Asked Questions
We have FAQs available on our website to help answer all of your Minn Kota
questions. Visit minnkotamotors.com and click on
“Frequently Asked Questions” to find an answer to your question.
Call Us (for U.S. and Canada)
Our consumer service representatives are available Monday – Friday between
7:00 a.m. – 4:30 p.m. CST at
800-227-6433. If you are calling to
order parts, please have the 11-character serial number from your product,
specific part numbers, and credit card information available. This will help
expedite your call and allow us to provide you with the best consumer service
possible. You can reference the parts list located in your manual to identify
the specific part numbers.
Email Us
You can email our consumer service department with questions regarding your
Minn Kota products.
To email your question, visit minnkotamotors.com
and click on “Support”.
Authorized Service Centers
Minn Kota has over 800 authorized service centers in the United States and
Canada where you can purchase parts or get your products repaired. Please
visit our Authorized Service Center page on our website to locate a service
center in your area.
COMPLIANCE STATEMENTS
ENVIRONMENTAL COMPLIANCE STATEMENT
It is the intention of JOME to be a responsible corporate citizen, operating in compliance with known and applicable environmental regulations, and a good neighbor in the communities where we make or sell our products.
WEEE DIRECTIVE
EU Directive 2002/96/EC “Waste of Electrical and Electronic Equipment
Directive (WEEE)” impacts most distributors, sellers, and manufacturers of
consumer electronics in the European Union. The WEEE Directive requires the
producer of consumer electronics to take responsibility for the management of
waste from their products to achieve environmentally responsible disposal
during the product life cycle.
WEEE compliance may not be required in your location for electrical &
electronic equipment (EEE), nor may it be required for EEE designed and
intended as fi xed or temporary installation in transportation vehicles such
as automobiles, aircraft, and boats. In some European Union member states,
these vehicles are considered outside of the scope of the Directive, and EEE
for those applications can be considered excluded from the WEEE Directive
requirement.
This symbol (WEEE wheelie bin) on product indicates the product must not be
disposed of with other household refuse. It must be disposed of and collected
for recycling and recovery of waste EEE. Johnson Outdoors Inc. will mark all
EEE products in accordance with the WEEE Directive. It is our goal to comply
in the collection, treatment, recovery, and environmentally sound disposal of
those products; however, these requirements do vary within European Union
member states. For more information about where you should dispose of your
waste equipment for recycling and recovery and/or your European Union member
state requirements, please contact your dealer or distributor from which your
product was purchased.
DISPOSAL
Minn Kota motors are not subject to the disposal regulations EAG-VO (electric
devices directive) that implements the WEEE directive.
Nevertheless never dispose of your Minn Kota motor in a garbage bin but at the
proper place of collection of your local town council.
Never dispose of battery in a garbage bin. Comply with the disposal directions
of the manufacturer or his representative and dispose of them at the proper
place of collection of your local town council.
REGULATORY COMPLIANCE INFORMATION
MICRO REMOTE
- Contains IC: 5123A-BGTBLE121LR
- Contains FCC ID: Q0QBLE121LR
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference that may be received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Johnson Outdoors Marine Electronics, Inc. could void the user’s authority to operate this equipment
NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
INDUSTRY CANADA COMPLIANCE
This product meets the applicable Industry Canada technical specifi cations.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired
operation of the device. Changes or modifications not expressly approved by
Johnson Outdoors Marine Electronics, Inc. could void the user’s authority to
operate this equipment.
TRADEMARKS
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Johnson Outdoors Inc is under license. Other trademarks and trade names are those of their respective owners.
ENVIRONMENTAL RATINGS
Ambient operating temperature range: -10C to 50C
Ambient operating humidity range: 5% to 95%
Maximum operating altitude: 10,000 feet
RADIO OPERATION
CONTROLLER
- Frequency band: 2402 MHz to 2480 MHz
- Maximum RF power transmitted: +10 dBm
REMOTE
- Frequency band: 2402 MHz to 2480 MHz
- Maximum RF power transmitted: +10 dBm
CE MASTER USER MANUAL (FOR CE CERTIFIED MODELS)
PARTS DIAGRAM & PARTS LIST
MICRO REMOTE
The parts diagram and parts list provides Minn Kota® WEEE compliance disassembly instructions. For more information about where you should dispose of your waste equipment for recycling and recovery and/or your European Union member state requirements, please contact your dealer or distributor from which your product was purchased. Tools required, but not limited to: flat head screwdriver.
i-PILOT MICRO REMOTE ⮞
⮞ Parts Diagram
Parts List
A | 2994079 | RMT ASY, MICRO BLUETOOTH | 1 |
---|---|---|---|
B | 2886422 | COVER, BATTERY COMPARTMENT ASY | 1 |
Item Part# Description
Quantity
2| 2390800| LANYARD w/CARABINEER,IP REMOTE| 1
4 .A.| X| INSTR. SHEET,iPLT MICRO BT| 1
6| X| BATTERY CR2450| 1
8| X| CASE-TOP, iPILOT MICRO REMOTE| 1
10| X| CASE-BTTM, MICRO BLUETOOTH| 1
12| X| PAD-FOAM, I-PILOT 1.5| 1
14| X| KEYPAD,iPILOT MICRO REMOTE| 1
16| X| COVER, BATTERY COMPRT| 1
18| X| GASKET,BATTERYCOMPARTMENT| 1
20| X| PCB ASSY, MICRO BLUETOOTH| 1
✖ This part is included in an assembly and cannot be ordered individually.
Not shown on Parts Diagram
RECOMMENDED ACCESSORIES
ON-BOARD & PORTABLE BATTERY CHARGERS
Stop buying new batteries and start taking care of the ones you’ve got. Many
chargers can actually damage your battery over time – creating shorter run
times and shorter overall life. Digitally controlled Minn Kota chargers are
designed to provide the fastest charge that protect and extend battery life.
TALON SHALLOW WATER ANCHOR
Introducing the all-new, sleek redesigned Talon. Talon is the only shallow water anchor with up to 15’ of anchoring depth, multiple anchoring modes, and control from the bow, transom, console, remote or mobile device
BUILT-IN WORK LIGHT
Lets you tie lines and work from
the transom any time of day — or night. Includes both white and blue LED
lights with three brightness settings.
BLUETOOTH® CONNECTIVITY
Lets you control Talon from your mobile device and easily update it. Also
opens up communication to other control options.
UP TO 15’ DEEP
Control more water and catch more fish with the first 15’ shallow water
anchor.
MORE CONTROL OPTIONS
- Control Panel
- Wireless Remote
- Mobile App
- Wireless Foot Switch
- Humminbird® Connectivity
- i-Pilot® &
i-Pilot LinkTM Remote
MINN KOTA ACCESSORIES
We offer a wide variety of trolling motor accessories, including:
- 60-Amp Circuit Breaker
- Mounting Brackets
- Stabilizer Kits
- Extension Handles
- Battery Connectors
- Battery Boxes
- Quick Connect Plugs
inn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
inn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>