KOHLER K-8304-PX Rite Temp Valve Body and Cartridge Kit User Guide
- June 9, 2024
- Kohler
Table of Contents
KOHLER K-8304-PX Rite Temp Valve Body and Cartridge Kit
Features
- Includes valve body, pressure balance cartridge, rough-in guide, and mudguard.
- ½” PEX Crimp (F1807 style) inlets.
- 1/2″ Universal NPT & direct sweat outlets.
- 5 gpm (18.9 l/min) maximum flow rate at 45 psi.
- Single lever design cycles from off through cold to hot.
- Antiscald protection.
- One-piece cartridge design simplifies installation and maintenance.
- Adjustable high-temperature limit stop to control maximum water temperature.
- Requires valve trim to complete installation (sold separately).
- Pressure-balancing diaphragm technology maintains outlet temperature within +/-3°F during water pressure fluctuations.
Material
- Forged dezincification-resistant brass body provides long term reliability and resistance to aggressive water conditions.
Installation
- Designed for use in standard, back-to-back and thin wall installations.
- Valve body features integral mounting locations and symmetrical valve inlets to simplify installation.
- Cartridge is reversible for installations where hot and cold supplies are reversed.
- Rough-in guide designed for both standard and thin wall installations.
- Installed valve rough-in can be flushed and pressure-tested to 150 psi max (air or water) without cartridge by using test cap (sold separately).
Optional Products/Accessories
- K-10350 Deep rough-in kit
- K-10351 Test cap for K-8300 Series valve bodies
Codes/Standards
ASME A112.18.1/CSA B125.1
ASSE 1016/ASME A112.1016/CSA B125.16
KOHLER® Faucet Lifetime Limited
Warranty
See website for detailed warranty information.
Features
Technical Information
All product dimensions are nominal.
Shower Valve:
- Pressure: 45 psi (3.1 bar)
- Maximum (Static) Pressure: 125 psi (8.6 bar)
- Minimum (Operating) Pressure: 20 psi (1.4 bar)
- Valve body: Machined-brass
Notes
Install this product according to the installation guide.
Avoid cross-flow conditions. Do not install shut-off device on either valve
outlet.
Cap the shower outlet if deck-mount spout, diverter, or handshower is
connected to the spout outlet.
Install straight pipe or tube drop of 7″ (178 mm) to 18″ (457 mm) with single
elbow between the valve and wall-mount spout.
For finished walls greater than 3/4″ (19 mm) and less than 1-1/2″ (38 mm),
install support(s) 2″ (51 mm) from the stud face.
For finished walls greater than 1-1/2″ (38 mm), install support(s) 3″ (76 mm)
from the face of the finished wall.
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product
specifications. For the most current Specification Sheet, go to
www.kohler.com.
7-23-2022 06:13 – US/CA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>