PHILIPS DMP116 Phase Cut Dimming Module Instruction Manual
- June 9, 2024
- Philips
Table of Contents
PHILIPS DMP116 Phase Cut Dimming Module Instruction Manual
Devices must be installed by a qualified electrician in accordance with all
national and local electrical and construction codes and regulations.
Output Ratings/Channel (CH)
Incandescent| 16 A| 16 A| 10 A|
Leading Edge / Trailing Edge
---|---|---|---|---
Magnetic with Halogen| 16 A| 16 A| 10
A| Leading Edge
Electronic Driver| 16 A| 16 A| 10 A|
Trailing Edge
*To ensure stable dimming operation, use the System Builder software to select the appropriate operating mode.
Default operating mode is Trailing Edge.
Output Ratings/Group
DMP116 ≤ 16 A
The manufacturer is not responsible
for dimmable lamp selection. Each lamp/dimmer combination must be tested for
compatibility prior to installation.
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency
Notice – This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help. Any modifications not approved by the
manufacturer of this device could void the user’s authority to operate this
device.
This Class B digital apparatus
complies with Canadian ICES-003: CAN ICES-3(B)/NMB-3(B). Cet appareil
numerique de la classe B est conforme a la norme NMB- 003 du Canada: CAN
ICES-3(B)/NMB-3(B). © 2022 Signify Holding. All rights reserved.
Specifications are subject to change without notice. No representation or
warranty as to the accuracy or completeness of the information included herein
is given and any liability for any action in reliance thereon is disclaimed.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips N.V. All other trademarks are owned by Signify Holding or their
respective owners.
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>