Oster GCSTBS5001 Steam Iron Instruction Manual

Oster GCSTBS5001 Steam Iron Instruction Manual

IMPORTANT SAFEGUARDS

When using an iron, basic precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING

1. Only use an iron for its intended use.
2. To avoid the risk of electric shock, do not immerse the iron in water or other liquids.
3. Always turn the iron OFF before plugging or unplugging the iron from the electrical outlet. Never pull on the cord to disconnect the iron from the electrical outlet; instead, grasp the plug and pull on the plug to disconnect the iron.
4. Do not let the cord touch hot surfaces. Let the iron cool completely before putting the iron away. Coil the cord loosely around the iron when storing.
5. Always disconnect the iron from the electrical outlet before filling the iron with water, emptying the water from the iron, and when the iron is not in use.
6. Do not operate the iron with a damaged cord or in the event the iron has been dropped, damaged or is leaking. To avoid the risk of electric shock, do not disassemble the iron. Take it to a qualified serviceman for examination and repair. Incorrect assembly might result in a risk of electric shock when the iron is used after reassembly.
7. Close supervision is required for any appliance used by or near children. Do not leave the iron unattended while the iron is connected or on an ironing board.
8. Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down – there might be hot water in the reservoir.
9. To avoid a circuit overload, do not operate an iron on the same circuit with another high wattage appliance.
10. If an extension cord is absolutely necessary, a cord with an ampere rating equal to or greater than the maximum rating of the iron shall be used. A cord rated for less amperage can result in a risk of fire or electric shock due to overheating. Care shall be taken to arrange the cord so that it cannot be pulled or be tripped over.
11. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
12. Always unplug electric iron before filling the water reservoir.
13. Do not open water reservoir during use.
14. Always use and rest appliance on a heat resistant, dry, stable, level surface.
15. To reduce the risk of contact with hot water emitting from steam vents, check appliance before each use by holding and facing it away from the body and operating steam button.
16. When filling the water reservoir, do not allow water to drip onto the floor.
17.  To avoid personal injury and damage to the appliance, only add water to the water reservoir. Never add cleaning solutions, perfumes, oils or any other chemical additives.
18. The use of attachments not recommended or sold by the appliance manufacturer may cause injuries or void your warranty.
19. Use caution while operating the appliance due to the emission of steam.

DESCRIPTION OF THE APPLIANCE

1. Soleplate
2. Spray Nozzle
3. Water Door
4. Steam Dial
5. Shot of Steam Button (only on model GCSTBS505X)
6. Strain Relief
7. Handle Top/Heel
8. Water tank
9. Spray trigger
10. Temperature Control Dial

BEFORE FIRST USE

• When using the Iron for the first time, test it on a piece of old cloth to be sure that the Soleplate and the Water reservoir are clean.
• It is possible that the Iron will discharge some smoke or give off a slight odor during it is first usage. This is due to the initial heating of the materials used. This is completely normal and will stop shortly afterwards.
• It is possible that the iron has a little of water inside before first use. This happens because the iron and steam function had been tested at the production. This doesn’t means that your iron was already used before.
• When not ironing, always have the Steam Select Switch turned to the close position .

INSTRUCTIONS FOR USE

CHOOSING THE RIGHT WATER

• This Steam iron may be used by normal tap water. However, if the water if the region in which you live is especially hard, it is recommended to use distilled water to prolong the life of your iron.
• Do not use water that has been desalinated with chemicals.

FILLING WITH WATER

1. Turn off the Iron and disconnect the plug from the electrical wall outlet before filling the Iron with water.
2. Turn the Steam Select Switch to the closed position .
3. Set the Iron in the position indicated below (Figure 2) and fill it with water, no higher than the Max fill level shown on the See-Through Water Window.

DRY IRONING

1. Insert the plug in the electrical wall socket.
2. Make sure that the Steam Select Switch is in the closed position .
3. After the Indicator Light goes off, you may start to iron.

STEAM IRONING
Steam ironing is only possible at high temperatures (silk, wool, cotton, linen), as indicated on the Temperature Control Dial (Figure 3).

1. Be sure that there is enough water in the Reservoir.
2. Set the iron in an upright position.
3. Plug the steam Iron into the wall electrical outlet.
4. Turn the Temperature Control Dial to the desired position within the range of temperatures included in the steam area of the dial.
5. Wait until the Indicator Light has turned off after lighting up.
6. Set the Steam Select Switch to the desired steam level position. You are now ready to start steam ironing. The steam will be released evenly through vents located in the soleplate for easier ironing.

SPRAY MIST
The Spray Mist feature is a powerful water spray mist that dampens the fabric to help remove wrinkles from heavy fabrics and to set creases.

1. Press the Spray Mist button firmly to start the spray.

SHOT OF STEAM (GCSTBS5051-52-53)
The Shot of Steam feature provides an extra burst of steam for deep penetration of stubborn wrinkles. The Shot of Steam feature can be used with dry or steam ironing provided it has at least a ¼ tank of water and the Temperature Control Dial is set within the steam band.

1. Allow the iron to heat for approximately two minutes.
2. Press the Shot of Steam Button several times to prime the pump.
3. Press the Shot of Steam Button another three to four times in order to clean the unit.
4. The Shot of Steam feature is now ready for use. The Shot of Steam feature can be used continuously with just a short pause between shots. The Shot of Steam feature is most effective with the Iron held in a horizontal position on the fabric being ironed.
5. If the Water Reservoir runs dry, unplug the Iron and refill with water. The Iron may be filled with water while it is hot. Note: It may be necessary to re-prime the pump before using the Shot of Steam feature again.

VERTICAL SHOT OF STEAM (GCSTBS5051-52-53)
The vertical shot steam feature allows your iron to function as a garment steamer.
TIP: When using the vertical shot of steam on clothing, hang the clothing on clothes hanger for best results. Hanging curtains and drapes may also be steamed.

HOW TO USE VERTICAL STEAM

1. Allow iron to warm up (2 minutes).
2. Hold the iron in a vertical position, with the iron close to but not touching the fabric you want to steam.
3. With your other hand, pull the fabric tight.
4. Press the Shot of Steam button in approximately 3-second intervals as you move the iron across the wrinkled area.

IRONING TEMPERATURE

• Check the ironing instructions on the label of the items that you wish to iron. Check the temperature setting table for further instructions.
• Should the specific ironing instructions not appear on the label, follow instructions on the temperature setting table. This table is only for fabrics indicated and does not apply to special textiles with a gloss finish, etc. Textiles with special coatings (such as gloss, relief wrinkles, etc.) are best ironed at very low temperatures. If the textile consists of several different type of fibers, always select the lowest temperature, i.e the temperature recommended for the most delicate fiber in the composition (for example, if the composition consists of 60% polyester and 40% cotton, you should iron at the temperature indicated for polyester).

SETTING THE TEMPERATURE

1. Set the iron in on upright position.
2. Connect the Iron to an electrical wall socket.
3. Set the Temperature Control dial (Figure 4) to the correct ironing temperature as indicated on the lable or the temperature settings table.

ANTI-CALC
The Anti Calc feature helps prevent the build up of mineral deposits in your iron. This prolongs its life and improves the iron’s performance.

MAINTENANCE AND CLEANING

Before cleaning the Iron, always make sure that it is disconnected from the electrical wall socket and is completely cool.

SOLEPLATE

• Residue on the Soleplate can be wiped off with a cloth soaked in a solution of water and vinegar.
• Do not use scouring pads, abrasives or chemical cleaning solvents as they may damage the finish.

HOUSING

• The housing can be cleaned with a moist cloth and then wiped dry.
• Other than the recommended cleaning, no further user maintenance should be necessary. If for any reason your Steam Iron should require repairs, do not try to fix it yourself. Send it to an Authorized Service Center (please refer to the warranty included in the box).

STORING THE IRON

1. Turn off the iron and disconnect the plug from the electrical wall socket.
2. Set the Iron in an upright position and let it cool down completely.
3. Set the Steam Select Switch to the closed position .
4. Empty out all the water remaining in the Water Reservoir by opening the Water Reservoir Lid and inverting the Iron over the sink.
5. The Power Cord can be wound around the Heel Rest for easier and tidy storing once the unit has cooled down. The Iron should always be stored in an upright position. Please visit your Oster website for more tips on ironing.

References

• ABREE - Associação Brasileira de Reciclagem de Eletroeletrônicos e Eletrodomésticos

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>