BOSCH PKF375CA2E-04 Domino Electric Hob Instruction Manual

BOSCH PKF375CA2E-04 Domino Electric Hob

Safe installation

• Follow these safety instructions when installing the appliance.
• Electrical connection must only be carried out by a licensed expert. An incorrect connection will invalidate the warranty.
• The safe operation of this appliance can only be guaranteed if it has been installed to a professional standard in accordance with these installation instructions. The installer shall be liable for any damage resulting from incorrect installation.

Built-under

• Do not install refrigerators, dishwashers, non-ventilated ovens, or washing machines underneath the appliance.
• If you fit an oven below the appliance, the worktop must be at least 20 mm thick, in certain cases even thicker. Observe the information in the oven installation instructions.

Combination with other hobs

If the appliance is combined with a gas hob, the worktop must be at least 20 mm thick. Follow the instructions in the installation instructions for the gas hob.

• Intermediate floor
• If the underside of the hob can be touched, an intermediate floor must be fitted.
• The minimum distance to the lowest point of the hob is 10 mm.

Preparing the units

• The worktop must be level, horizontal, and stable.
• The fitted units, including wall finishing strips, must be heat-resistant to at least 90 °C.
• Niche cladding within 50 mm of the back wall must not be combustible (e.g. tiles, stone).
• Seal the cut surfaces to make them heat-resistant.
• This prevents the worktop from swelling as a result of moisture. → Fig. 1

Electrical connection

• Observe the country-specific guidelines.
• In order to prevent dangerous situations, if the power cord of this appliance is damaged, it must be replaced by the manufacturer, the manufacturer’s customer service or a similarly qualified person.
• The appliance fulfills the requirements of protection class I and must only be operated in conjunction with an earth conductor.
• In the permanent electrical installation, a partition must be provided in the phases in accordance with the installation regulations.
• If appears on the appliance’s display, it has not been connected correctly. Disconnect the appliance from the mains and check the connection.
• Ensure that there is sufficient fuse protection for the household wiring.
• Observe the color coding of the power cable
• Green and yellow
• Protective conductor
• Blue
  • Neutral for mains voltage connection 220-240 V
  • Phase (external conductor) for mains voltage connection 400 V
• Brown/black Phase conductor (external conductor)

Installing the hob

• Do not use silicone to bond the appliance to the worktop.

Note: Do not kink or trap the connection cable, and keep it away from sharp edges and hot parts.

• If the oven is a built-under type, route the cable along the rear corners of the oven to the main socket.
• Use at least 4 retaining springs to secure the appliance. → Fig. 2

Removing the hob

1. Disconnect the appliance from the power supply.
2. Loosen the retaining springs.
3. Push out the hob from below.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>