ZiPWAKE IT300-S Adaptor for BTS To Or Hulls with Protruding Bottom Plate Installation Guide

INSTALLATION GUIDE
ADAPTOR FOR BTS TO ZIPWAKE AND/OR
HULLS WITH PROTRUDING BOTTOM PLATE
ZIPWAKE IT300-S & IT450-S

IT300-S Adaptor for BTS To Or Hulls with Protruding Bottom Plate

NOTE! Refer to the main Installation Guide when mounting!

Test to see how the adaptor fits on the transom

1. NOTE! Remove old sealant/dirt from the transom ensuring a smooth and clean surface for adaptor plate to mount to and to ensure a good seal with o-ring.
   Max 2 mm (0.08″) between parallel planes.

2. Temporarily fit the interceptor back plate onto the adaptor. Use straight edges to determine the adaptor position and mark the top on the transom.

NOTE! Protruding hull:
Cut off the lower edge of the adaptor with a right-angle grinder if necessary!

Use the adaptor as a drill template

NOTE! For BTS replacement go straight to step 3!

Prepare the transom for optional concealed thru-hull fitting

NOTE! For thru-hull fittings above the waterline go straight to step **4!![ZiPWAKE IT300 S Adaptor for BTS To Or Hulls with Protruding Bottom Plate

• optional concealed](https://manuals.plus/wp-content/uploads/2023/04/ZiPWAKE- IT300-S-Adaptor-for-BTS-To-Or-Hulls-with-Protruding-Bottom-Plate-optional- concealed.png) NOTE!** Refer to the main Installation Guide on how to prepare the interceptor for concealed thru-hull fitting!

Mount the adaptor

4. NOTE! Make sure to align the top edge of the adaptor with the mark on the transom!

Mount the Interceptors

NOTE! Refer to the main Installation Guide for sealing, cabling and final mounting!

www.zipwake.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>