BerronTech ET030 5M Digital Tape Measure User Manual
- September 11, 2024
- BerronTech
Table of Contents
BerronTech ET030 5M Digital Tape Measure
Warranty Card
Model|
---|---
Sales date|
User name|
Phone|
Address/Lip Code|
Warranty records|
App scan code download:
Parameters
Digital tape measure
| s e e a “ oe| ****
191111 X 511
---|---|---
Accuracy| Steel: II,
digital accuracy:±1mm
Resolution| 1mm (1 /16 Inch)
Range| 1mm – Sm (1 /l 61nch-l 6.4FT)
Unit
| mm, cm, m, Inch x 0.1 , FT x 0.01, Inch x 1 /16 & FT
Communication Interface| ****
Wireless
|
Power supply
| ****
Battery
| Built-in rechargeable lithium battery, 500mAh
Charge adapter| Type-C,5V500mAh
Auto-sleep| 605
Auto-turn off
| ****
30min
Display and key
| ****
Key
| Key x 4
OLED display| 128 x 64 resolution, monochrome
LED
| ****
Red/charging indicator
Cover
| Material| ABS,TPE
Weight/size
| ****
248g/84x68x35mm
Env ironment
| Temperature| Operating O”C ~ 40°C, Storage -20°C ~ 60°C
Humidity| <85%
Operation Introduction
- Before the operation, please download and install the “Liangyiliang” APP.
- Open the “Liangyiliang” APP to complete the pairing. After pairing for the first time, it will connect automatically.
- Press the MION key to turn it on and pull out the tape measure to measure. The effective measurement distance is the ruler hook to the measurement base.
- Press the MION key to confirm the measurement data and upload it to the APP.
Note : When measuring, please note that the measurement base is set to the front base or the rear base.
Key Description
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.