marta MT-1998 Electric Thermo-Pot User Manual
- June 9, 2024
- MARTA
Table of Contents
marta MT-1998 Electric Thermo-Pot User Manual
DESCRIPTION
- Lid opening lever
- Pump
- Pump lock lever
- Handle
- Water gauge
- Control panel
- Housing
TECHNICAL SAFETY
When using electrical appliances, basic safety precautions should always be observed including the following:
- Before connecting the appliance, check if the voltage indicated corresponds with the mains voltage in your home.
- To protect against electrical shock do not immerse body, cord or plug in water or other liquid.
- Place the airpot on a flat surface, at least 30 cm away from stove or other heat source.
- Do not fill any liquid except clean water.
- Do not fill water directly from a tap water faucet. Use a pitcher or kettle to keep electrical parts safe from splashes of water.
- Never plug into the power source without filling the pot with water. Do not over fill the pot with water and always check if the water level needs new supply.
- Avoid splashes of water on the airpot’s body especially on the top portion to prevent electrical shocks. In accidental case of water splashes, wipe it dry immediately.
- Do not let cord hang over edge of table or counters, or touch hot surfaces.
- Do not operate any appliance with damaged cord or plug or after the appliance malfunction of has been damaged in any manner.
- In case of damaged mains cord, it must be replaced by a repair shop authorized by the manufacturer.
- Keep the airpot away from children, handicapped and elderly persons. They should be supervised if they are going to dispense water from the airpot to prevent accidents and burn injuries.
- Unplug from outlet when not in use and before cleaning. Allow to cool before putting or taking off parts.
OPERATION
Tips and reminders when filling water:
Never fill water in excess. Doing so will cause water overflow when boiling
and may damage body while heating water. It may also damage the airpot after a
short period of time. Never fill water directly from a tap water faucet to
avoid short-circuit and electrical shock. Be sure to close the top cover and
lock it.
Note: Closing the top cover creates a clicking sound. Plug it in to the
power source. The red indicator lights up to indicate the heating process.
Never open the top cover or fill the airpot with water during boiling. Do not
cover the steam vent. When water has boiled, the red indicator turns off and
the green indicator lights on signaling the keep warm state (temperature
approximately 98°C).
When dispensing hot water, press the pressure pad with enough force to bring
out water from the airpot. Exercise caution and extreme care when dispensing
hot water from the airpot to prevent accidents and burn injuries.
Press the lid opening switch to unlock the lid’s top cover and open it.
Pour water into the airpot up to the “MAX” water mark.
Close the top cover and lock it. Closing the top cover creates a clicking
sound.
Plug it in to the power source. The red indicator lights up to indicate the
heating process.
When water has boiled, the red indicator turns off and the green indicator
lights on signaling the keep warm state (temperature approximately 98°C).
When dispensing hot water, press the pressure pad with enough force to bring
out water from the airpot.
CLEANING AND MAINTENANCE
When cleaning the airpot, make sure to unplug from the power source and the
hot water has cooled down completely before taking it out from the airpot. It
is advisable to clean the airpot inside and outside before using for the first
time.
Cleaning the airpot scheduled once a month or as desired to ensure water
quality and to lengthen service life of inner pot.
When the airpot is not going to be used for a long time, it should be cleaned
and dried before sealing in a plastic bag and stored in a safe, dry place.
TECHNICAL SPECIFICATION
- Power supply: 230 V ~ 50 Hz
- Power: 750 W
- Net weight / Gross weight: 2,50 kg / 2,90 kg
- Dimensions (L х W х H): 270270410mm
- Capacity: 4,2 l
WARRANTY DOES NOT APPLY TO CONSUMABLES (FILTERS, CERAMIC AND NON-STICK
COATING, RUBBER SEALS, ETC.)
Production date is available in the serial number located on the
identification sticker on the gift box and/or on sticker on the device. The
serial number consists of 13 characters, the 4th and 5th characters indicate
the month, the 6th and 7th indicate the year of device production. Producer
may change the complete set, appearance, country of manufacture, warranty and
technical characteristics of the model without notice. Please check when
purchasing device.
MANUFACTURER: COSMOS FAR VIEW INTERNATIONAL LIMITED – ROOM 701, 16 APT, LANE
165, RAINBOW NORTH STREET, NINGBO, CHINA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>