CandCNC RC400 Remote Console Wireless Tablet User Guide
- June 9, 2024
- CandCNC
Table of Contents
RC400 REMOTE CONSOLE
WIRELESS TABLET
User Guide
RC400 Remote Console Wireless Tablet
- Over 50 functions done IN SYNC with PC Console…use either one.
- High Resolution 600 X 1024 screen image.
- Real 802.11 WIFI Networking for reliable error free communications.
- MORE than a simple JOG pendant.
- Complete SETUP functons for 8 way jog, homing, axis zeroing, increment precise jog to a spot, special setup functions.
- Support for Plasma (with DTHC) , Router (with Spindle) and Oxy-Fuel
- Usable with all 64 bit CommandCNC™ installs including older MESA/UBOB models.
- Includes updated release of CommandCNC (Free).
- Complete Instruction Manual with section for WIFI setup.
- Free Software Updates for 1 year. Low cost Maintenance afterwards.
- Price Includes Pre-Loaded 7 x 10 tablet.
- Limited Time Offer .
- 1 Year Warranty* Low cost tablet replacement fee of $95.00 exchange .
-
- warranty does not cover physical damage to tablet
The RC400 is a multifuction Remote Console designed to work with LINUX based CommandCNC™ running on specicifc hardware. The Android based application only runs with CommandCNC Release 1.3.0 or higher (supplied with the “kit” and comes pre-loaded on a tablet supplied by CandCNC. It will not run on an Android Phone, or any IOS based device. The application is licensed to run with a specific CommandCNC™ based controller and will not connect or communicate with any other controller or even another CommandCNC controller its not licensed to run with This prevents one tablet from interfering with, or controlling other machines with a similar tablet. Thus one tablet can control ONE machine / controller its licensed to.
Run time DTHC controls allow for precise remote control of all the DTHC
functions . Manual Torch ON/OFF, DTHC ON/OFF,
DTHC AUTO/MANUAL TORCH DISABLED (test run) VELOCITY ANTI-DIVE ON/OFF (VAD) ,
AUTOSET ON/OFF.
PREREQUISITES
- CommandCNC™ 1.1.0 64 bit or higher on LINUX 18.04*
- CandCNC Bladerunner Ethercut, G5/G5A/G5XL , MP3700 or any upgraded system with EBOB or older UBOB with MESA 7i92 card.
- ugrade to CommandCNC™1.3.0 or higher is prvider free with RC400 purchase.
If ordered with a new system the upgrade will be inwsd and tested.
COPYRIGHT NOTICE: All images and content of this documant are the exclusive property of Fourhills Design LLC and CandCNC. Any reproduction in part or whole is prohibited without the written permission of the copyright holder.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>