truVision TVTH-S01-0001-TUR-G Thermal Turret Camera Installation Guide
- June 8, 2024
- TruVision
Table of Contents
- truVision TVTH-S01-0001-TUR-G Thermal Turret Camera
- Caution
- What’s In The Box
- Installation environment
- Installation Instructions
- Symbols used in the graphics
- Unpacking
- Camera description
- Setting up the camera
- Technical specifications
- Legal information
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
truVision TVTH-S01-0001-TUR-G Thermal Turret Camera
https://firesecurityproducts.com/en/bu/video.
Caution
What’s In The Box
Installation environment
When installing your product, consider these factors:
- Electrical: Install electrical wiring carefully. It should be done by qualified service personnel. Always use a proper PoE switch or a 12 VDC UL-listed Class 2 or CE-certified power supply to power the camera. Do not overload the power cord or adapter.
- Ventilation: Ensure that the location planned for the installation of the camera is well-ventilated.
- Temperature: Do not operate the camera beyond the specified temperature, humidity, or power source ratings. The operating temperature of the camera is between -40 to +65°C. Humidity is below 90%.
- Servicing: Do not attempt to service this camera yourself. Any attempt to dismantle or remove the covers from this product will invalidate the warranty and may also result in serious injury. Refer all servicing to qualified service personnel.
- Cleaning: Do not touch the sensor modules with your fingers. If cleaning is necessary, use a clean cloth with some ethanol and wipe the camera gently. If the camera will not be used for an extended period, put on the lens cap to protect the sensors from dirt.
Installation Instructions
Symbols used in the graphics
- Depending on the camera model, the number of items may vary, or skip the step if not applicable.
- MicroSD card
- Disposal
- Ground
- Warning
- Correct
- Incorrect
Unpacking
Check the package and contents for visible damage. If any components are damaged or missing, do not attempt to use the unit; contact the supplier immediately. If the unit is returned, it must be shipped back in its original packaging.
Camera description
- Debugging serial port
- Memory card slot
- Reset button
- Power connection
- Alarm connection
- RS-485
- Audio input
- Audio output
- Network connection
Local storage
Insert a Micro SD card with up to 256GB to use the camera as an additional
recording device, or as a backup in case of failure of communication with the
network video recorder. The card is not supplied with a camera. Recorded video
and log files can be accessed via the web browser or via TruVision Navigator.
Setting up the camera
Once the camera is mounted, set up its network and streaming parameters so that it can be controlled over the network, and program it as appropriate for its location. Refer to the camera’s configuration manual for further information, which is available on our website.
Technical specifications
Electrical
Voltage input| 12 VDC, PoE 802.3af
Power consumption| 12 VDC ± 25%: 0.5 A, Max. 6.5 W
Miscellaneous
Connectors| AC/DC Power, Network, Audio, Alarm In/Out
and Video
Operating temperature| -40 to +65 °C
Dimensions| 138 × 138 × 123 mm
Weight| 940 g
Legal information
© 2021 Carrier. All rights reserved. Specifications are subject to change without prior notice.
TruVision names and logos are a product brand of Aritech, a part of Carrier. Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products. While every precaution has been taken during the preparation of this manual to ensure the accuracy of its contents, Carrier assumes no responsibility for errors or omissions.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>