PHILIPS 945571166 Hue Wall Switch Module User Manual
- June 4, 2024
- Philips
Table of Contents
945571166 Hue Wall Switch Module
User Manual
Hue personal
wireless lighting wall switch module
945571166 Hue Wall Switch Module
http://www.philips-hue.com/wallswitchmodulesupport
Work on Electrical installations 1s 1n some counties only allowed by a
qualified election. For support contact a local electrician or authority to
install the product in accordance with national and electrical codes.
The electrical circuit and attached bright source will always be powered after
installation. turn off the circuit breaker when replacing a light
fixture/battery
Wire Connectors Instructions:
- Turn off power before installing or removing connectors
- Step wires 5/16″(7.9mm) For #16 and smaller wires. step 3/8″(95mm).
- Pre-twisting is unnecessary, hold stripped wires together with ends even
- Push wires into connector and screw on unbl two twists are visible in wires
For use with copper to copper conductor
Temperature Rating 105°C (221 “F) Max.
Voltage Rating; 600V Max building winning. 1000V Max. in fixtures and signs
Listed as a PRESSURE· TYPE wire connector on the following Solid wire
combinations
For UL Listed. CSA Certified
Max. wire size (AWG); 22 – 10
Splice capacity: 3+ around 
http://www.philips-hue.com/wallswitchmodulesupport
Terminal screw Positions may vary per manufacturer.
www.philips-hue.com
www.philips-hue.com/wallswitchmodulesupport
Signify North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA
Signify Canada Ltd/Signify Canada Ltee.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Questions or Comments/ Questions ou commentaires :
1-800-555-0050
lmportardo y/o distribuido en Mexico por:
Signify Mexico S.A. de CV.
Av. La Palma N° 6-Col. San Fernando,
La Herradura Huixquilucan
Edo. De Mexico, C.P. 52784 – R.F.C. PME-620620-E84
Centro de contacto:
01-800-508-9000
© 2021 Signify Holding
All rights reserved
www.philips-hue.com
3222 639 07221
Last update: 02/2021
Please go to www.philips-hue.com to learn more
about Hue and how to use it. This device complies with Part 15 of the FCC
Rules and with the RSS of Industry Canada. Operation is subject to the
following two conditions· (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. This Class B digital
apparatus complies with Canadian ICES-003. This digital apparatus does not
exceed the Class B limits for radio-noise emissions from digital apparatus as
set out in the Radio Interference Regulations of the Canadian Department of
Communications.
NOTICE: Changes or modifications made to this device not expressly
approved by Signify North America Corporation (“Signify”) may void the U.S.
FCC and Canadian authorization to operate this device.
The advanced interface module complies with FCC radiation exposure limits set
forth for an uncontrolled environment.
This device should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment Such modifications could void the
user’s authority to operate the equipment.
This device has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful Interference in a residential
installation. This device generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this device does cause harmful interference to radio or television reception.
which can be determined by turning the device off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures
– Reorient or relocate the receiving antenna
– Increase the separation between the device and receiver
– Connect the device into an outlet on a circuit different from that to which
the receiver is connected
– Consult the dealer or an experienced radio/television technician for help
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
Caution: To maintain compliance with the FCC’s RF exposure guidelines,
place the product at least 20cm from nearby persons.
SAFETY INSTRUCTIONS
Electrical devices may only be mounted and connected by electrically skilled
persons.
Serious injuries, fire, or property damage are possible.
Please read and follow the manual fully.
DANGER! Electrical shocks when live parts are touched can be fatal.
DANGER! Risk of fire when wrongly installed.
DANGER! Mortal danger of electric shock.
Before working on the device or performing an installation, disconnect all the
corresponding circuit breakers. Cover up live parts!
Maintenance work, e.g. exchanging batteries. may only be carried out by an
electrically skilled person.Even a lamp that is visibly switched off is
permanently supplied with mains voltage. Switch off the circuit breaker before
replacing the lamp, or battery.
The lamp that is controlled by this product is still supplied with mains
voltage.
This product itself is not connected to mains voltage.
Always check local legislation on the use of the product as local regulations
could forbid the use in certain setup situations.
Installation in the United States requires a minimum of one light switch in a
room/light point must be able to physically disconnect the power.
During installation and cable routing, comply with the regulations and
standards which apply to SEL V circuits.
Do NOT input mains voltage. This product is supplied with a battery.
The supplied wire nut needs to connect the lamp to the main power.
Radio communication takes place via a non-exclusively available transmission
path. and Is therefore not suitable for safety-related applications, such as
emergency stop and emergency calls.
These instructions are an integral part of the product and must remain with
the end customer.
Ensure always to install the product according to the local electrical code.
Perchlorate Material – special handling may apply
WARNINGS AND CAUTIONS:
Keep away from liquids and humidity.
The product is for indoor use only.
Do not use in wet locations, areas directly exposed to water, or outdoors.
This product is not a toy designed to be played with by children.
Do not place on hot surfaces.
For safety reasons and under the terms of the warranty, none of the enclosed
devices should be opened.
Risk of explosion if the battery is replaced by an incorrect replacement.
Batteries should be installed by an adult.
Different types of batteries and new and used batteries must not be mixed.
Batteries are to be inserted with the correct polarity.
The supply terminals must not be short-circuited.
Do not use rechargeable batteries.
Non-rechargeable batteries must not be charged.
Exhausted batteries must be removed from the product.
Remove batteries when the product is not in use for some time.
CAUTION: Do not ingest battery – Chemical burn hazard. This product
contains a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just two hours and can lead
to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and
keep it away from children.
If you think that batteries might have been swallowed or placed 1ns1de any
part of the body, seek immediate medical attention.
SPECIFICATIONS
Rated voltage: DC3V
Battery type: CR 2450
Temperature (operation): 32 … 104°F
Temperature (Storage): -40 .. 176°F
Relative humidity(operation): 0-80%
Relative humidity(storage). 0-90%
Features of automatic action: Type 1 action
Control pollution degree: Pollution degree 2
Wireless communications protocol: IEEE 802.15.4
Operating channels: channels 11 – 26
Radiofrequency: 2.400 … 2.483 GHz
Maximum transmitted power <20 dBm
Installing the Hue Wall Switch Module on or near metal surfaces may lead to a
reduced range.
CUSTOMER SUPPORT:
For more information, please visit our website at www.philips-
hue.com/support, or call our customer
service (1-800-555-0050).
Signify North America Corporation
200 Franklin Square Drive, Somerset, NJ 08873, USA
Signify Canada Ltd./Signify Canada Ltee.
281 Hillmount Road, Markham, ON, Canada L6C 2S3
Hue PersonalWireless Lighting’ is a trademark owned by Signify Holding B.V.
Philips and the Philips shield emblem are registered trademarks of Koninklijke
Philips N.V.
References
- Smart lighting | Philips Hue US
- Smart lighting | Philips Hue
- Philips Hue Support - FAQs | Philips Hue US
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>