INVACARE DTEC013831 Height Adapters Instruction Manual
- June 8, 2024
- INVACARE
Table of Contents
INVACARE DTEC013831 Height Adapters Instruction Manual
Assembly instructions
Please read carefully the complete assembly instructions before you start the assembly!
ACCESSORIES
-
1. Height adapter 2 cm (4 pieces)- incl. conversion kit order no. 15170
- extension kit without conversion kit order no.14694
- Assembly instructions (1 page)
ASSEMBLY OF THE FRONT HEIGHT ADAPTERS
- Take out the suction cup lid from the base plate and remove the suction cup with toggle by pulling it backwards (cannot be used anymore).
- Replace the suction cup lid in the keyhole bore of the base plate.
- Place the adapter insert (4) in the keyhole bore so that the nose on the bottom side matches with the groove at the base plate.
- Screw the height adapter (1) with the threaded bolt (2) from below into the thread on the adapter insert (4).
- Screw the new suction cups (3) into the height adapter.
ASSEMBLY OF THE REAR HEIGHT ADAPTERS
- Unscrew the suction cups from the base plate of the bathlift.
- Screw in the height adapters (1) with corresponding threads (2) from below into the thread of the base plate.
- Screw the suction cup (the one you unscrewed) into the height adapter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>