Lumens OIP-AC01 6U Rack Mount Chassis Installation Guide
- June 8, 2024
- Lumens
Table of Contents
OIP-AC01
Quick Installation Guide
PACKAGE CONTENTS
| 6U Rack Chassis | Installation Guide | Power Adapter |
|---|---|---|
| Power Connector | M5 Screw x8 | Cable Clip x5 |
| (Appearance may vary depending on country/region |
Power & System Requirements
- Power Requirement: DC 12V, 3A power supply for the cooling fan system.
- System Requirement:
- The 6U rack chassis requires a minimum of 266.7mm (10.5in) contiguous free space in the rack for mounting.
- With the Cooling Fan System installed, an additional 1U space above the chassis should be left empty to provide space for air to flow freely.
Installation Instructions
STEP 1
Install the OIP-AC01 to the rack with M5 Screws*8pcs.
STEP 2
Unscrew the 3 thumbscrews holding the top locking panel in place, and remove
the panel from the front of the chassis. Unscrew the 3 thumbscrews holding the
bottom locking panel in place, and remove the panel from the front of the
chassis.
Note: The thumbscrews are connected to the locking panels with a
retention mechanism and will not come completely free when they have been
unscrewed from the chassis.
STEP 3
Align and then carefully slide a full or half-length compatible audio/video
unit into the top/bottom grooves of a free slot. Half-length units are
designed with a notch to prevent them from sliding all the way to the back of
the rack chassis. Repeat this step until all units have been installed.
Note: If fewer than 15 units are being mounted it is strongly suggested
to leave empty space between units that get particularly warm to improve
airflow and heat dissipation.
STEP 4
Reattach the top and bottom locking panels by screwing in the 3 thumbscrews on
each until they are tight and secure.
Note: Be careful to not overtighten the thumbscrews as this could damage
the screw threads.
STEP 5
Connect DC 12V, 3A power supply to the cooling fan system
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>