A-iPower AP4000 4000 Watt Portable Generator User Guide
- June 8, 2024
- A-iPOWER
Table of Contents
A-iPower AP4000 4000 Watt Portable Generator
Generator Quick Start Guide
Unpack Generator: Remove generator, accessories, inserts and Literature from carton. If any item is missing or damaged, contact our product service department at 1-855-888-3598.
Included Items
WARNING: This Quick Reference Guide is not substitute for reading the
operator’s manual. To reduce the risk of injury or death, user must read and
understand the operator’s manual before using this product. All pages
references to the operator’s manual.
-
Install the wheel kit
Slide the axle pin(A) through the wheel(B), flat washer(C) and mount point on the frame(D). Secure them with cotter pin(E).
Attach the support leg(G) to the generator frame with flange bolt(F)(M8X16) and flange lock nut(H)(M8)
-
Install the Handle Assy
Unscrew bolts (I) and nuts (K) on the handle, insert bolts (I) throught the handle (J) and holes on the generator frame as shown. Tighten bolts (I) and nuts (K). -
Add Lubricant and Fuel
Use a funnel to pour provided engine oil into engine. Fill to the upper mark of the oil dipstick H.
Use clean / fresh regular UNLEADED gasoline with a minimum 87 octane.
-
Adjust Shock-absorbing Seat
Before operating the generator, the shock-absorbing seat (cushion) must be adjusted for proper clearance. Loosen the lock nut and adjust the shock- absorbing seat so there is a 3mm gap between the top of the seat and the bottom of the motor bracket. Re-tighten the lock nut.
-
Start Generator
Move generator outside to a flat, level surface, away from doors, windows and vents.
DANGER
Using a generator indoors CAN KILL YOU IN MINUTES. Generator exhaust contains
carbon monoxide. This is a poison you cannot see or smell.
Avoid other generator hazards. READ MANUAL BEFORE USE.
WARNING Do not overload generator or electrical cords. Consult operation manual.
Turn fuel valve under tank to ON position
Turn engine switch located on control panel to ON position
Move choke lever located on engine to START position
Pull cord starter to start engine 
Move choke lever to RUN Position 
Plug in items to be powered, using only grounded extension cords 
Shutdown and Storage
Remove any load from the generator
Run the generator at no load for 2 minutes and then turn engine switch to OFF position
Turn fuel valve to OFF(O)position
If generator is to be stored for longer than 30 days, refer to The operator’s manual for further Instruction.
Questions? Call 1-855-888-3598 or email support@a-ipower.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>