Batsystem PB120 Anchor Rol Instruction Manual
- June 8, 2024
- Batsystem
Table of Contents
Batsystem PB120 Anchor Rol
PB120 – Mounting instructions
NOTE: This boat accessory is only
to be used at sea
You will need this:
Parts:
Assembly
The steel frame may be adjusted in width, if necessary. Loosen mounting bolts first then secure again.
Mounting of brackets for gennaker and Code-0
Strut and Code-0 attachment MUST be mounted at the same point.
Use Sikaflex on the fittings.
Seal with Sikaflex wide the attachments to the hull.
Without anchor roller
Use any holes for mounting of code-0
With anchor roller
Use any hole 4+5 or 5+6 for mounting of code-0
Customize the teak after the bow shape.
Fit the plate on the bottom of the teak.
Anchor roll
Loosen the fittings (for starboard or port). Cut an opening in the teak.
BU76P-12 – Mounting instructions
You will need this:
Content
Ladder:
Assembly map
BKT73A – Mounting instructions
You will need this:
Content
Ladder:
Assembly
Make sure that the frame sides are mounted parallel so that the ladder does
not get stuck when it
folds in.
Customer Support
Båtsystem AB, Traneredsvägen 112, 426 53 Västra Frölunda, Tel: 031-69 03
80, Fax: 031-690097,
www.batsystem.se,
info@batsystem.se
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>