PHILIPS AVENT Trainer Cup Instructions
- June 8, 2024
- Philips
Table of Contents
PHILIPS AVENT Trainer Cup
Read all instructions carefully before use. Keep the user manual and product packaging for future reference. For your child’s safety and health
WARNING!
– Continuous and prolonged sucking of fluids will cause tooth decay. – Always
check food temperature before feeding.
– Throw away at the first signs of damage or weakness.
– Keep components not in use out of the reach of children.
– Never attach to cords, ribbons, laces or loose parts of clothing. The child
can be strangled.
– Never use feeding teats as a soother.
– Always use this product with adult supervision.
It is not recommended to use a microwave to warm up baby food or drinks.
Microwaves may destroy valuable nutrients in food/drinks and may produce
localized high temperatures. If you decide to use the microwave, take extra
care to stir heated food/drinks to ensure even heat distribution and check the
temperature before serving. Only place the container in the microwave, without
the screw ring, teat and cap. Do not allow children to play with small parts
or walk/run while using bottles or cups. Always discard any breast milk that
is left over at the end of a feed. Inspect before each use and pull the
feeding teat in all directions.
Throw away at the first signs of damage or weakness. Do not use trainer cup
parts with glass bottles.
Before first use
Disassemble all parts, clean and then sterilize the parts by placing in boiling water for 5 minutes or sterilize by using a Philips Avent sterilizer. This is to ensure hygiene.
Assembly
Make sure that the feeding teat is fully pulled through the screw ring as
shown in the image (Fig. 1, 2).
Cleaning and storage
Clean all parts before each use to ensure hygiene. After each use, disassemble
all parts, wash in warm, soapy water, remove any food residues and rinse
thoroughly. If you
use a brush to clean the tip of the feeding teat, clean it as carefully as
possible to avoid damage. Then sterilize using a Philips Avent sterilizer or
boil for 5 minutes. Make sure that you wash your hands thoroughly and that the
surfaces are clean before contact with sterilized components. During
sterilization with boiling water, prevent the parts from touching the side of
the pot. This can cause irreversible product deformation, defect or damage
that Philips cannot be held liable for. Food colorings may discolor parts.
This product is dishwasher safe.
Do not place the product in a heated oven.
Do not bring the cup parts in contact with or place on surfaces with abrasive
or antibacterial cleaning agents. We recommend replacing feeding teats every 3
months. Keep feeding teats in a dry, covered container. Do not leave a feeding
teat in direct sunlight or heat, or leave in disinfectant (sterilizing
solution) for longer than recommended, as this may weaken the teat.
Compatibility
Replacement teats are available separately. To learn more about choosing the right teat for your baby, visit us at www.philips.com/avent. These cup parts are compatible only with Philips Avent Natural teats.
Support
If you need information or support, please visit www.philips.com/support.
www.philips.com/avent
Philips Consumer Lifestyle B.V.
Tussendiepen 4, 9206 AD Drachten,
The Netherlands / les Pays-Bas / Paesi Bassi
Trademarks are the property of Koninklijke
Philips N.V. / Les marques commerciales sont la
propriété de Koninklijke Philips N.V. / I marchi
commerciali e depositati sono di proprietà di
Koninklijke Philips N.V.
© 2021 Koninklijke Philips N.V.
All rights reserved. / Tous droits réservés. /
Tutti i diritti riservati.
3000.072.4211.2 (14/10/2021)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>