ACCUREX RX series Weighing Indicators User Manual
- June 8, 2024
- ACCUREX
Table of Contents
ACCUREX RX series Weighing Indicators
Keypad Functions
- Off function.
- On function and function selection during normal operation and configuration.
- Zero display and set zero point or enter a tare value.
- A weight is tare and display net weight.
Display Status
Mains power is applied to the indicator.
A weight has been tarred and display the net weight.
Zero display.
Weight is stable.
The display is temporarily set to high resolution.
The unit of weighing is lb.
Calibration
- Press the key continuously and switch on the device (do not release the key at any time) Wait for a short beep and release suddenly.
- Let the counting cycle continue and when finished press the key. will be displayed.
- Press the key. 〖CAL 00〗 will come out.
- Press the key. The unit will perform a zeroing operation and the weight to be calibrated will be displayed (default total capacity – e.g. 60.00)
- If you want to change the calibration value, press the key and 0000.00 will appear.
- Press until the digit to be modified flashes, then press to modify it to the desired value (e.g. 10k = 0010.00) Place the calibration weight on the scale.
- Once the weight has been deposited, press the key and the calibration will be performed and the actual weight will appear. Calibration completed.
A/D Counts Display
- Press【ON/】three times, display〖-A-d-〗, press【→T←】, display〖123456〗, A/D (Digital/Analog) counts 123456, press the【ON/】to return to weighing mode.
Select Display Mode
- In normal weighing status, press【ON/】for 2 seconds, unit of weighing is lb, press【ON/】for 2 seconds, unit of weighing is kg.
Zero
- When the weight is stable, press【→0←】, display〖 0.00〗, zero status LED is turned on. Zero range is ± 2%FS.
Tare and Remove Tare
- Tare: When Tare status LED is off and the weight is ≥0 and stable, press【→T←】 to acquire tare and switch to net mode, the tare status LED is turned on.
- Remove tare: When Tare status LED is on, press【→T←】 will switch to gross mode and removed tare. The tare status LED is off.
Battery Capacity
- When after turn on indicator, display〖bt 85〗is battery capacity.
Low Battery Warning
- When the battery is capacity less than 10% of full charge, display will flash. When the battery has no power, the indictor display〖 bAtt 〗turn off immediately.
LED Error Code
- Display〖 OUEr〗, weight > FS + 9d, display〖 –OUEr 〗, weight < -2% FS, Display〖 Error〗, calibration error.
Gram Precision S.L. Travesía Industrial, 11 · 08907 Hospitalet de Llobregat · Barcelona (Spain) Tel. +34 902 208 000 · +34 93 300 33 32 Fax +34 93 300 66 98 comercial@gram.es www.gram-group.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>