NATIONAL Tree COMPANY Pre-Lit Artificial Christmas Hanging Baskets Instructions
- June 8, 2024
- NATIONAL Tree COMPANY
Table of Contents
NATIONAL Tree COMPANY Pre-Lit Artificial Christmas Hanging Baskets
SHAPING
The product is shipped from the factory with the branch tips compressed to the center. Each branch tip must be shaped to its proper position to give the product a natural look. This will also bring the piece to its advertised dimension. The care and attention given to this final process will result in a genuinely beautiful and appealing holiday decoration. Shaping is done by gently grasping the branch tips and spreading them out away from the center.
BATTERY INSTALLATION (if equipped)
Open battery compartment and insert batteries observing proper polarity (+/–).
OPERATION
Pressing the ON/OFF button once will turn on the lights and begin the timer.
The timer will run continually: 6 hours with lights on, then 18 hours with
lights off and repeat until deactivated by pressing ON/OFF button.
WARNINGS
- This product is for seasonal decoration only and not intended for permanent installation or use.
- Do not mix old and new batteries. Replace all batteries at the same time.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickelcadmium) batteries or equivalent.
- Do not use rechargeable batteries.
- Do not dispose of batteries in fire. Batteries may explode and cause injury.
STORAGE
To avoid leakage and corrosion, remove batteries from battery compartment
before storage. Store product in a cool, dry location, protected from
sunlight.
FCC CAUTION
CAUTION: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
2 Commerce Drive, Cranford, NJ 07016 www.nationaltree.com