BODYCRAFT F715 Hold Down Attachment Kit Owner’s Manual
- June 9, 2024
- BODYCRAFT
Table of Contents
BODYCRAFT F715 Hold Down Attachment Kit
F715 Hold Down / Attachment Kit Option
for the BodyCraft F705 and F605 Benches
Owner’s Manual
To see in
FULL COLOR
& additional information, scan this QR code.
Base Lot Number: _
Purchased Date: / / __
Dealer’s Name:__
Please register your products at:
https://www.bodycraft.com/product-registration/
Assembled Parts List
| Part # | Assembly Parts list | QTY |
|---|---|---|
| F715-001-ASM | LEG WEIGHT HOLDER – Assembly | 1 |
| F715-002-ASM | ADJUST TUBE – Assembly | 1 |
| F715-003 | FOAM ROLLER HOLDER | 2 |
| F715-004 | FOAM ROLLER | 4 |
| F715-005 | END CAP, LARGER | 4 |
| F715-006 | END CAP, SMALLER | 4 |
| Part # | Assembly Hardware | QTY |
| --- | --- | --- |
| F715-007 | BIG WASHER, φ8 – BLACK | 4 |
| F715-008 | HEX RECESSED HEAD BOLT, 5/16″ x 1-1/4″ – BLK | 4 |
| F715-009 | HEX BOLT, 1/2″ x 4-1/4″ – BLACK | 2 |
| F715-010 | NYLON LOCK NUT, 1/2″ – BLACK | 2 |
| F715-011 | FLAT WASHER, 1/2″ – BLACK | 4 |
THE FOLLOWING TOOLS ARE RECOMMENDED FOR ASSEMBLY
Product Assembly
Place all parts from the box in a cleared area and position them on the floor
in front of you.
Remove all packing materials from your area and place them back into the box.
Do not dispose of the packing materials until assembly is completed.
Read each step carefully before beginning.
NOTE: Confirm centered with equal distance on both Right & Left Sides.
STEP 1c: Secure Foam Rollers
Then slide a HEX RECESSED HEAD BOLT, 5/16″ x 1-1/4″ (8) through the END CAP,
SMALLER (6) and the BIG WASHER, φ8 (7). Hand tighten at this time with an 7/32
Allen Wrench.
STEP 2a: Adjustment Tube Holder
Insert the preassembled ADJUST TUBE – Assembly (2-ASM) from STEPS 1a-c, by
pulling out on the PULL-PIN LOCKING KNOB (13) and slowly lowering onto the LEG
WEIGHT HOLDER – Assembly (1-ASM).
STEP 2b: Install Hold Down / Attachment Kit
Option
Attach the HOLD DOWN / ATTACHMENT KIT (F715) to a BodyCraft bench of choice,
either an F601, F605, F705 or F708. Use the following hardware:
- Two HEX BOLTS, 1/2″ x 4-1/4″ (9)
- Four FLAT WASHER, 1/2″ (11)
- Two NYLON LOCK NUT, 1/2″ (10)
STEP 2c: “Torque Time”
Tighten all Bolts at this time to the Recommended Torque Specs, as shown in
the diagram to the right.
STEP 3: Installation Example
Remove handle from bench, then Install the preassembled Hold Down / Attachment
Kit to a BodyCraft bench.
Detailed Parts List & Parts Exploded View
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>