LANCOM SYSTEMS IAP-4G Plus LTE 4G Router User Guide

June 4, 2024
LANCOM SYSTEMS

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router LOGO

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router PRODUCT

Wall mounting

Use the supplied screws to fix the back plate to the wall using the holes A, C and E.

Top hat rail mounting

Using the supplied screws, attach the two top-hat rail clips to the holes A and C. Do not yet tighten the screws completely; leave some play to adjust the alignment of the clips.

Pole mounting

For mast mounting, use the supplied screws to fix the clamp profile through the holes B and D.

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router 3Align the four openings on the rear of the device housing with the clips on the base plate and snap-fit the device.

Top-hat rail mounting only

Snap the two top-hat rail clips onto the required position on the top-hat rail.

Mast mounting only

Insert the supplied worm-drive clip (or one suitable for your pole diameter) around the mounting clamp profile. Finally, adjust the worm-drive clip to fix the device in the desired position on the mast.

Optional

Secure with a Kensington lock

The left side of the device features a slot for a Kensington lock. The Kensington lock securely fixes the device to the mounting plate.

Parts Overview

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router 4

LTE-/ 4G antennas

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router 4

Screw the supplied antennas onto the terminals 4G Main and 4G Aux.

Power

After connecting the cable to the device, turn the connector 90° clockwise to prevent it from accidental unplugging. Use only the supplied power adapter.

Serial configuration interface

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router 7

Configuring the device via the serial interface requires a serial configuration cable (available as an accessory).

Reset button

Pressed up to 5 seconds: device restart. Pressed until first flashing up of all LEDs: configuration reset and device restart

Ethernet interfaces

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router 9Use the Ethernet cable to connect one of the interfaces. ETH1 or ETH2 to your PC or a LAN switch. Alternatively, you can connect one of the ETH interfaces to the PoE Injector’s ‘Power Out’ connector.

SIM card slot

Slide the SIM card into the slot of the SIM card holder. Please note the marking for the correct position of the card. To prevent the device from overvoltage damage, an overvoltage-protected power supply is strongly recommended sensible at all times.

MOUNTING AND CONNECTING UP TJE CHNICAL DETAILS  THE  DEVICE

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router 11

LANCOM SYSTEMS IAP-4G Plus LTE 4G Router KK

The additional power LED statuses are displayed in 5 seconds rotation if the device is configured to be managed by the LANCOM Management Cloud. This product contains separate open-source software components which are subject to their own licenses, in particular the General Public License GPL.The license information for the device firmware (LCOS) is available on the device‘s WEB config interface under Extras > License information. If the respective license demands, the source files for the corresponding software components will be made available on a download server upon request.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

LANCOM SYSTEMS User Manuals

Related Manuals