SERVER 07794 Express Pumps Instruction Manual
- June 8, 2024
- SERVER
Table of Contents
SERVER 07794 Express Pumps
ASSEMBLY
-
* INSERT PINCH VALVE- INSTALL DOME
- INSTALL TUBE
- INSERT CONNECTOR
- SELECT DISCHARGE FITTING
- INSERT DISCHARGE FITTING
SAFETY
According to food and safety regulations, most foods must be stored and/or served at certain temperatures or they could become hazardous. Check with local food and safety regulators for specific guidelines. Server Products, Inc. cannot be responsible for the serving of potentially hazardous product.
DISASSEMBLY
CLEANING
- FLUSH & RINSE all pump surfaces with hot water. Place lower end of pump into container of hot water and operate pump until all remaining product is expelled and only hot water is discharged.
- DISASSEMBLE & CLEAN all washable parts with soap and hot water. Use brush to clean any confined areas.
- RINSE fully with clear water.
- SANITIZE all parts according to local sanitization requirements. All parts in contact with food must be sanitized.
- AIR DRY all parts fully
Use dishwashing soap, hot water and nylon brush
- Dishwasher safe
- Do not use abrasive, caustic or ammonia based cleansers.
- Do not use cleansing agents with high concentrations of acid, alkaline or chlorine.
- Do not use metal scrapers or cleaning pads that could scratch surfaces.
TROUBLESHOOTING
DIFFICULT TO ATTACH PARTS?
Wet parts with clean water to help fit.
THE PRODUCT DOESN’T PUMP?
- Ensure pinch valve is inserted in housing.
- Ensure connector is snapped fully in place to fitment in pouch.
- Ensure pump is properly installed in unit.
- Clean pump thoroughly
DOME POPS OFF?
- Clean thoroughly. Food residue could prevent a tight seal between dome and housing.
- Ensure dome edges are flush with housing.
WARRANTY
SERVER PRODUCTS LIMITED WARRANTY
2-YEAR WARRANTY This Server product is backed by a two-year limited warranty against defects in materials and workmanship. See Server-Products.com for details.
GENERAL SERVICE, REPAIR OR RETURNS
Before sending any item to Server Products for service, repair, or return, contact Server Products customer service to request a Return Authorization Number. Merchandise must be sent to Server Products with this number. Service is extremely prompt. Typically, units are repaired and ship out within 48 hours of receipt. Merchandise being returned for credit must be in new and unused condition and not more than 90 days old and will be subject to a 20% restocking charge.
NEED HELP?
- Server Products Inc.
- 3601 Pleasant Hill Road
- Richfield, WI 53076 USA
Chat with us! Example:
- [email protected]
- 262.628.5600
- 800.558.8722