Optoma Aura Pro Running Board Lights Installation Guide
- June 8, 2024
- Optoma
Table of Contents
Optoma Aura Pro Running Board Lights
COMPONENTS
INSTALLATION
- STEP 1 Inspect kit to ensure all contents was included.
- STEP 2 Decide where to locate the control box and ensure wiring has enough length for light bars to be installed in desired location.
IMPORTANT:
The control box must be installed inside the vehicle as it is not waterproof.
Avoid installation areas of the engine bay + heated surfaces.
As shown below, connect all the LED bars to the control box with the included extension cables.
OPTION A
OPTION B
Once connected, plug the control box Cigarette Power Adapter into an available
12 volt charging port.
or connect the positive wire to the fuse tap and connector the open negative wire to a ground (any metal surface). Then plug the fuse tap into the 10amp switched fuse.
IMPORTANT: Connecting to more then 10amp will override the kit and cause
early failure, ensure it is 10amps or less!
WARNING: Please ensure that the led bars or strips/control box/wiring all are mounted in areas where will not exceed 85C or 185F.
- STEP 3 Scan the QR code on the back of the control box to download the app.
- STEP 4 Secure Control box in desired location with Velcro or zipties.
- The control box is NOT waterproof. Tuck it away from the elements.
- STEP 5 Secure the light bars using the zip ties to tie all the wiring away from the moving components.
IMPORTANT:
The LED connectors are not waterproof. You will need to use HEAT SHRINK TUBE
(not included) or ELECTRICAL TAPE around the LED connectors to ensure the
longevity of the lighting kit.
STEP 6
- Open the OPT7 AURA App, pair your smart device to the control box, and pick your desired color!
AUX WIRING FOR A DOOR/DOME LIGHT
Please scan to see a detail instruction on Door Assist Sync or go to
https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide
OPT7 CONNECT APP
- Colors
- Modes
- Door Assist
- Support
- Ability to control up to 4 devices at once
QR CODE TO DOWNLOAD
Download the free “OPT7 CONNECT” App
- App iOS (12+) available on App Store
- Android (6 +) available on Google Play
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance. OPT7 recommends installation for safety and guidance. Modified installations or installation recommendations not specified by OPT7 Lighting will void product warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>