Shark RV2400WD IQ 2-in-1 Robot Vacuum and Mop with Matrix Clean User Guide
- June 8, 2024
- Shark
Table of Contents
Shark RV2400WD IQ 2-in-1 Robot Vacuum and Mop with Matrix Clean
Robot Setup
-
Set Up Dock + Landing Mat
- Remove protective film from robot and dock.
- Place dock in a spot with a strong Wi-Fi signal.
-
Attach Side Brush
Note: Side brush design may vary. -
Place Robot on Dock
- Robot will turn on when properly placed on dock.
- Blue LED light on the dock indicates robot is charging.
-
Scan the QR code to download the SharkClean® app.
What’s Included
-
Robot Dock
-
Landing Mat
-
Fluid Reservoir
-
Mopping Pad
Two Easy Steps If You’re Stuck
- Visit: sharkclean.com/support
- Owner’s Guide
- Troubleshooting
- How-To Videos
- FAQs
- Tips & Tricks
- For additional help, call
1-888-228-5531 for robot support.
Maximize Your Robot Experience
Tips and tricks for getting the most out of your robot.
- To manually turn ON /OFF your robot, hold down the DOCK button for 6-8 seconds.
- Clear the area of cords and wires before each clean.
- Use mopping mode for daily maintenance and stuck-on messes.
- Only use Shark® VACMOPTM cleaning solution or water when mopping.
- Always place your robot on a level surface when performing maintenance.
- Clean brushroll and filter regularly.
© 2022 SharkNinja Operating LLC. SHARK and SHARKCLEAN are registered trademarks of SharkNinja Operating LLC. VACMOP is a trademark of SharkNinja Operating LLC. APPLE and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. APP STORE is a service mark of Apple Inc., registered in the U.S. and other countries. GOOGLE, GOOGLE ASSISTANT, GOOGLE PLAY, the Google Play logo, and Android are trademarks of GOOGLE LLC.