Ebac DEL080-V3 Powerdri Professional Dehumidifier User Manual
- June 8, 2024
- Ebac
Table of Contents
- Ebac DEL080-V3 Powerdri Professional Dehumidifier
- Introduction
- Before operation
- Setting the controls – Version 1
- Setting the controls – Version 2
- Fan speed control
- Fitting the Drainage Kit
- Accessories
- How to purchase
- Warranty
- How to Register
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Ebac DEL080-V3 Powerdri Professional Dehumidifier
Introduction
The first time you plug in your new Ebac dehumidifier, you’ll begin to realise the difference it will make to your home. You’ll be amazed at just how much water this quiet, yet powerful unit extracts and stores in its container. It’ll get you thinking where it all comes from and where it’s been going all these years. Incredibly, the average family produces 20 pints/12 litres of moisture a day. However, that’s one fact you needn’t worry about now. Your Ebac dehumidifier is designed to cope with everything you do that adds even more moisture to the British climate. Everything from showering to washing up, boiling a kettle to breathing – they all add moisture to the air. This brochure will help you get the very best out of your Ebac and not only protect your home from the damaging effects of condensation and damp, but also improve the quality of your air. During installation and maintenance, respect the precautions indicated in the manual, and on the labels applied inside the units, as well as all the precautions suggested by good sense and by the safety regulations in effect in your country.
It’s surprising what an Ebac can do for your home
There’s a lot more to your Ebac dehumidifier than preventing damp and condensation damage. It could actually improve your health. Damp conditions provide the ideal breeding ground for dust mites. So, if you suffer from an allergy or asthma aggravated by dust mites, lower humidity levels may help. Also, sufferers of arthritis, bronchitis and rheumatism may also find relief from drier, warmer air. Economy-wise, your Ebac dehumidifier costs typically 2p an hour to run. It can even lower your heating bills, as moist air absorbs heat. This is then removed and channelled back into the atmosphere to raise temperatures by up to 3°C. Plus, being light and portable, every room in the house can benefit too. Once your condensation problem is under control, your dehumidifier will extract from 1 to 2.5 litres of water per day.
Important
Your Ebac Powerdri is packed in a plastic wrapping; please ensure that it is disposed of safely where it will not be a danger to children
Before operation
- Stand your dehumidifier upright for at least 2 hours prior to operating.
- Open the water container door, remove the water container – replace and close the door.
- This will reset the sensors which may have been activated during transit.
Getting the most from your Powerdri
- Ensure internal doors are kept ajar where possible to allow air circulation.
- Ensure external doors and windows are kept closed as much as possible
- Ensure the unit is positioned on a flat, even surface.
Setting the controls – Version 1
Humidistat
Turn the humidistat to the appropriate symbol on the dial. When drying is
complete switch off the dryer by turning the Humidistat to its lowest setting
and unplugging the dryer from the mains. When using for automatic humidity
control initially turn to the highest setting, when signs of excess moisture
are reduced, gradually turn the humidistat dial anti-clockwise to the point
where the dryer just switches off. This level of humidity will now be
maintained. If signs of excess moisture re-appear, increase the humidistat
setting slightly until the problems are again under control
Setting the controls – Version 2
Humidistat
Turn the humidistat dial to the appropriate symbol on the fascia and the
indicator light will show amber. When drying is complete, switch off the dryer
by turning the Humidistat to its lowest setting and unplugging the dryer from
the mains. When used for automatic humidity control, initially turn clockwise
to the highest setting and the indicator light will show amber, when signs of
excess moisture are reduced, gradually turn the humidistat dial anti-
clockwise. As you turn the dial anticlockwise each position sets a target
relative humidity (RH) which is lower the further it is turned, once the
target RH is achieved the indicator light will turn green. This level of
humidity will now be maintained. If signs of excess moisture re-appear,
increase the humidistat setting slightly until the light turns amber. After
adjusting the humidistat always allow 5 minutes for the unit to start
dehumidifying.
Setting
- Mid humidistat setting for homes with general moisture levels
- Control unwanted moisture wherever it occurs
- Assists with indoor laundry drying
- Dry rooms and plaster quickly and effectively
- High humidistat setting for maximum extraction
Fan speed control
To adjust the fan speed, turn the fan speed dial to the desired position.
Setting Function
- Low/Quiet Setting
- High Setting for maximum extraction
Emptying the water container
The red light on the control panel will illuminate when the container if
full. When this occurs, water collection stops.
Cleaning the filter
Your Powerdri has a filter to remove dust from the air. This filter should
be cleaned every month and replaced every 3 to 4 months dependent upon usage.
Failure to do this will reduce the performance of your dehumidifier and may,
over time lead to a permanent reduction in performance.
Using the Permanent Drainage Facility
Your dryer can be used in unattended dwellings such as holiday homes
without emptying the water container. To enable this facility you must use the
permanent drainage kit supplied.
Fitting the Drainage Kit
-
* Remove the permanent drainage seal from the rear of the unit.
- To prevent this being mislaid this is attached to the rear of the panel of your dryer.
- Locate the end of the drainage tube with the bleed hole.
- Push this end of the tube onto the permanent drainage outlet (it may help to dip the end of the tube in hot water for a few seconds to soften it) ensuring that the bleed hole is located at the top.
- Ensure that the tube is securely attached to the drainage outlet and route the pipe ensuring that
Looking after your Powerdri
Your Powerdri requires very little maintenance, however, to maximise performance clean the filter every month (replacing every 3 to 4 months dependent upon usage) and every 6 months you should check the drainage system as follows
- Using a standard matchstick or small plastic bottle brush, remove any residue from the water drain outlet above the water container (left hand side).
- Pull out the permanent drainage bung from the rear of the unit.
- This should then be pushed in and out a few times to remove any build up inside the drain tray (have a cloth or other absorbent material handy to catch the water).
- The bung should then be pushed fully home to reseal the drain tray
If your Powerdri fails to operate
Always check the following list before requesting a repair service. Should a service call be requested and the fault is found to be detailed below, a charge may be incurred.
The power indicator light is not illuminated.
Check
- The unit is switched on at the mains. If necessary test the socket by plugging in another appliance.
- Check the fuse in the plug and if necessary replace with another 13 amp fuse. If you continue to have problems please see ‘Requesting Service’.
Power indicator light is illuminated, but the unit is not collecting water.
Check
- Version 1 – The humidistat (if activated) may be set too low, increase the setting. Version 2 –
- If the indicator light is green the unit has reached the RH level, turn the dial clockwise until the indicator turns amber.
- The water container may be full, empty the container.
- Ensure the water container is fitted. If you continue to have problems please see ‘Requesting Service’.
Reduced water extraction.
Check
- Version 1 – The humidistat (if activated) may be set too low, if signs of condensation or dampness remain, increase the setting. Version 2 – If the indicator light is green the unit has reached the RH level, if signs of condensation or dampness remain, turn the dial clockwise until the indicator turns amber.
- The filter may be blocked. Remove, clean and refit.
- After being installed all dehumidifiers will collect less moisture as initial excess moisture is removed. This is normal.
- The dehumidifier may be positioned next to a heat source i.e. a radiator – reposition. If you continue to have problems see ‘Requesting Service’.
Red water container light remains on all the time and the dehumidifier is
not running (Normal when the water container is full).
Check
- Ensure the water container is not full.
- Ensure the water container is fitted. If you continue to have problems see ‘Requesting Service’.
Requesting service
Before requesting a service call please read the section ‘If your Powerdri fails to operate correctly’ and follow any advice this offers. If after following this advice you still experience problems please obtain the following information then either log on to www.ebac.com/faq and use our quick and easy diagnostics system to resolve your problem or contact our customer service desk on 0345 805 0000 (UK only)
Technical and safety information
- Min Operating Temperature 3°C
- Max Operating Temperature 35°C
- Fuse Rating 13 amp
Warnings for using R290 refrigerant only
- The appliance contains R290 gas (A3 flammability classification).
- Do not use any means to accelerate the defrosting process.
- When cleaning the appliance this should be limited to the exterior panels and filter, following the guidelines within this manual
- If the appliance is installed, used or stored in an unventilated room, the room must be such as to prevent stagnation of possible leaks of refrigerant gas as there could be a danger of fire or explosion should the refrigerant come into contact with electric heaters, stoves or other sources of ignition.
- The appliance shall be stored in a well-ventilated area where the room size corresponds to the room area as specified for operation (4 m² this equates to a 2 meter by 2 meter room).
- The appliance shall be stored in a room without continuously operating ignition sources (for example: open flames, an operating gas appliance or an operating electric heater).
- Do not pierce or burn.
- Be aware that the refrigerants may not contain an odour.
- Appliance should be installed, operated and stored in a room with a floor area larger than 4 m² (this equates to a 2 meter by 2 meter room).
- This appliance contains ≤90g of R290 refrigerant gas
Explanation of symbols displayed on the unit:
Accessories
Activated Carbon Filter Pack Model no. DDA507
Contains 3 Activated Carbon Filters. Carbon filters are ideal for homes with
pets or smokers as they remove odours from the air creating a more pleasant
atmosphere. Note that this pack does not include the filter housing. The
filter housing is available at an extra charge.
Activated Carbon with Antibacterial Filter Model no. DDA510
Contains 3 Activated Carbon with Antibacterial filters. The special
antibacterial formulation protects against germs and other airborne particles,
killing all known bacteria and many fungi, ensuring a cleaner and healthier
home. Note that this pack does not include the filter housing. The filter
housing is available at an extra charge.
Castor Kit Model no. DDA268
Although lightweight and portable adding a castor kit to your dehumidifier
makes it easier to move as it can be simply wheeled to a desired location.
Drainage Kit Model no. DDA110
The permanent drainage kit allows your dehumidifier to be used in unoccupied
situations such as holiday homes, cellars etc without the need for the water
container to be emptied. Supplied with the Powerdri unit
Water Container Model no. DDA200
Replacement water container in case anything should happen to the one supplied
with your dehumidifier
Filter Housing Model no. DEA171
The filter housing is specific to Powerdri dehumidifiers
How to purchase
Online Log on to www.ebac.com
Post Complete and send the attached form to: Ebac Ltd, Ketton Way,
Aycliffe Business Park, Newton Aycliffe, County Durham, DL5 6SQ
Warranty
Warranty Registration
Thank you for purchasing an Ebac Dehumidifier. Powerdri 18 dehumidifiers are covered by a standard one year warranty from the date of purchase. Powerdri 21 dehumidifiers are covered by a standard three year warranty from the date of purchase. Registration of your unit ensures you can take full advantage of your warranty so don’t hesitate and register today
How to Register
There are two simple methods of registering your Ebac Dehumidifier Warranty
- Online Log on to www.ebac.com/warranty
- Post Complete and send the attached form to: Ebac Ltd, Ketton Way, Aycliffe Business Park, Newton Aycliffe, County Durham, DL5 6SQ
Why Register?
- You can take full advantage of your Ebac warranty.
- Fast repair service carried out by Ebac with the unit collected and delivered from and to the place most convenient to you.
- All parts and labour included.
- Your details are on record which enables us to help you much faster.
- You can choose to sign up to our mailing list to receive the latest product information and up to date offers.
What’s covered?
Your dehumidifier will receive unlimited repairs for any mechanical failure within the period of the warranty.
- The costs associated with the collection, repair and return delivery of the dehumidifier.
- The warranty covers dehumidifiers in domestic use in Great Britain and Northern Ireland.
- Visit www.ebac.com/warranty for Terms and Conditions.
What’s not covered?
- The warranty does not cover wear and tear to the unit exterior or air filter.
- You may be charged if no fault is found or the fault is due to user error.
- The warranty does not cover accidental damage.
Choose your optional marketing preferences
- News and Information
- Special Offers and Promotions
- Reviews and Feedback
- To help Ebac with Product Development
- To carry out Product Testing
- Helpful Advice and Articles
- Product Surveys
- None
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>