ALPICAIR YAP1F7 Wireless Controller Owner’s Manual
- June 4, 2024
- ALPICAIR
Table of Contents
ALPICAIR YAP1F7 Wireless Controller Owner’s Manual
Thank you for choosing our product.
Please read this Owner’s Manual carefully before operation and retain it for
future reference.
1. Operation and introduction of remote controller
1.1 Buttons on remote controller
1.2 Introduction for icons on display screen
1.3 Introduction for buttons on remote controller
ON/OFF
Press this button to turn on the unit. Press this button again to turn off the unit.
MODE
Press this button to select your required operation mode.
NOTE
- Under on and off status, you can set T-OFF or T-ON simultaneously.
- Before setting T-ON or T-OFF, please adjust the clock time.
- After starting up T-ON or T-OFF,set the constant circulating valid.
- After that, air conditioner will be turned on or turned off according to setting time. ON/OFF button has no effect on setting. If you don’ t need this function, please use remote controller to cancel it.
1.4 Function introduction for combination buttons
Energy-saving function
Under cooling mode, press “TEMP” and “CLOCK” buttons simultaneously to start up or turn off energy- saving function. When energy-saving function is started up, “SE” will be shown on remote controller, and air conditioner will adjust the set temperature automatically according to ex-factory setting to reach to the best energy-saving effect.
Press “TEMP” and “CLOCK” buttons simultaneously again to exit energy-saving function.
NOTE
- Under energy-saving function, fan speed is defaulted at auto speed and it can’t be adjusted.
- Under energy-saving function, set temperature can ‘t be adjusted. Press “TURBO” button and the remote controller won’t send signal.
- Sleep function and energy-saving function can ‘t operate at the same time. If energy-saving function has been set under cool mode, press SLEEP button will cancel energy-saving function. If sleep function has been set under cool mode, start up the energy-saving function will cancel sleep function.
NOTE
- Under CC heating function, fan speed is defaulted at auto speed and it can’t be adjusted.
- Under CC heating function, set temperature can ‘t be adjusted. Press “TURBO” button and the remote controller won’t send signal.
- Sleep function and CC heating function can’t operate at the same time. If 80C heating function has been set under heat mode, press SLEEP button will cancel CC heating function. If sleep function has been set under heat mode, start up the 8 oc heating function will cancel sleep function.
- Under OF temperature display, the remote controller will display 460F heating.
1.5 Replacement of batteries in remote controller
NOTICE
- During operation, point the remote control signal sender at the receiving window on indoor unit.
- The distance between signal sender and receiving window should be no more than 8m, and there should be no obstacles between them.
- Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone; remote controller should be close to indoor unit during operation.
- Replace new batteries of the same model when replacement is required.
- When you don’t use remote controller for a long time, please take out the batteries.
- If the display on remote controller is fuzzy or there ‘s no display, please replace batteries.
Read More About This Manual & Download PDF: