A-iPower SUA8000iE 8000 Watt Generator User Guide
- June 9, 2024
- A-iPOWER
Table of Contents
A-iPower SUA8000iE 8000 Watt Generator
Generator Quick Start Guide
Unpack Generator: Remove generator, accessories, inserts and Literature from carton. If any item is missing or damaged, contact our product service department at 1-855-888-3598.
WARNING
This Quick Reference Guide is not substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and underdstand the operator’s manual before using this product. All pages references to the operator’s manual.
Battery Connection and Adding Lubricant and Fuel
Use a funnel to pour provided engine oil into engine. Fill to the upper mark of the oil dipstick H
Use clean / fresh regular UNLEADED gasoline with a minimum 87 octane.
NOTE: The generator comes equipped with the positive cable A (with red boot) already attached.
- Verify the positive (+) battery cable A with red boot is securely tightened to the positive (+) battery post. Make sure boot is over battery post.
- Remove bolt B (M6x12) and nut C from battery negative (-) post.
- Locate negative (-) battery cable D with black boot and attach to the negative (-) battery post. Tight the cable with bolt B and nut C. Cover the post with black boot.
Start Generator
- Move generator outside to a flat, level surface, away from doors, windows and vents
WARNING Do not overload generator or electrical cords. Consult operation manual.
DANGER
Using a generator indoors CAN KILL YOU IN MINUTES. Generator exhaust contains carbon monoxide. This is a poison you cannot see or smell.
- Add gasoline to the fuel tank.
- Turn the LOW IDLE switch to “OFF”position.
- Turn the Multi-Switch to the“START” position.
- Electric start
- Recoil start Flip the engine switch to the “ON”(l) position. Pull the starter cord slowly until resistance is felt and then pull rapidly.
- When engine starts,turn the Multi-Switch in to the “RUN” position.
Shutdown and Storage
- Remove any load from the generator.
- Press the engine switch to the “OFF”(O) position.
- Recoil start Flip the engine switch to the “ON”(l) position. Pull the starter cord slowly until resistance is felt and then pull rapidly.
- When engine starts,turn the Multi-Switch in to the “RUN” position.
- Turn the Multi-Switch to the “OFF” position.
If generator is to be stored for longer than 30 days, refer to the operator’s manual for further instruction.
Questions? Call 1-855-888-3598 or email support@a-ipower.com ¿Tiene preguntas? Llame al 1-855-888-3598 o escriba a support@a-ipower.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>