GOAL ZERO 65 W USB-C Charger User Guide
- June 9, 2024
- GOAL ZERO
Table of Contents
65 W USB-C Charger
User Guide
65 W USB-C Charger
The equipment specifications are on the equipment or its package.
The socket-outlet shall be installed near the equipment and shall be easily
accessible.
Your consumer rights are governed by the law of the country in which you
purchased the product. Please contact Goal Zero support for any assistances.
The disconnection from line voltage is made by pulling the mains plug. The
socket-outlet shall be installed near the equipment and shall be easily
accessible.
This marking on the product, accessories or literature indicates that the
product and its electronic accessories (e.g. charger, headset, USB cable)
should not be disposed of with other household waste.
Class II equipment
To identify equipment meeting the safety requirements specified for Class II
equipment according to IEC 61140.
For indoor use only
To identify electrical equipment designed primarily for indoor use.
Alternating current
To indicate on the rating plate that the equipment is suitable for alternating
current only; to identify relevant terminals.
Direct current
To indicate on the rating plate that the equipment is suitable for direct
current only; to identify relevant terminals.
NOTE: Keep this user guide and packaging for reference.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
GOAL ZERO HEADQUARTERS
Draper, UT 84020
1-888-794-6250
goalzero.com
Designed in the U.S.A.
Made in China
CL050422V4
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>