AINIRO HX-008 Biometric Gun Safe for Handgun User Guide

: June 2, 2024
: AINIRO

Table of Contents

AINIRO HX-008 Biometric Gun Safe for Handgun
Product Overview
Usage Instructions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AINIRO HX-008 Biometric Gun Safe for Handgun

Product Overview

AINIRO HX-008 Biometric Gun Safe for Handgun 1

A. Digital Button
B. Fingerprint
C. Keyhole
D. Add: add digital password or fingerprint
E. Delete: delete fingerprint
F. Reset: clear digital password and all fingerprints

Usage Instructions

Step 1. Use your key
Note : Keep the key outside the storage box!
Step 2. Install the battery
Please load 4 AA 1.5 Volt alkaline batteries into the battery box (The unit does not contain batteries).
Step 3. Reset your device

1. Make sure the batteries are installed.
2. Quick press the “Reset” button 3 times continuously and you will hear 2 beeps. Then the initial factory data will be cleared.

Step 4. Add digital password

1. Press the “Add” button, then add the digital password (5-15 digits) and press the “OK” button. You will hear a beep after pressing the “OK” button.
2. Enter the same digits again and press the “OK” button. You will hear two long beeps if setting successfully. Otherwise, it will beep three times rapidly.![AINIRO HX-008 Biometric Gun Safe for Handgun 4](https://manuals.plus/wp-content/uploads/2024/03/AINIRO-HX-008-Biometric-Gun-Safe-for-Handgun-4.png)

Note : Be sure to press the “OK” button when you enter the digital password. Only one set of digital passwords can be set. Multiple groups of digital passwords are not supported.

Step 5. Add fingerprints

1. Be sure to add digital password successfully before adding fingerprints.
2. Press the “Add” button and put your finger on the designated place 6 times. You will hear 2 long beeps at the 6th time if setting successfully.
3. Repeat the above step if you want to add more fingerprints.

Note : The fingerprints can be add up to 30 groups. Don’t press the fingerprint area hard when adding fingerprints.

How to delete the fingerprint?

Press the “Delete” button, the indicator will flash red. Simply put the finger on the scanner to delete the first fingerprint.
Note : The indicator continues flashing red after you delete the first fingerprint. During this period you’re able to delete other fingerprints by putting your tinger on the scanner one by one. It you want to exit the deletion, just press the “Delete” button again.

Warm Tips:
If you want to delete the Digital passwords, press the Reset button.

Note : Reset button means to clear all the data (including digital passwords and fingerprints). You will need to add new digital password and fingerprints after resetting.

Need more help?