airlive POE-GSH420-60 6-Port Gigabit PoE+ Switch User Guide
- June 4, 2024
- airlive
Table of Contents
airlive POE-GSH420-60 6-Port Gigabit PoE+ Switch
Installation Steps
Figure A
| Symbol | Indicator Function | State | Description | Colour |
|---|
PWR
| ****
Work indicator
| On| Normal| ****
Green
Off| Switch no power supply or failure
Blink| System abnormality or failure
PoE
| ****
PoE
| On| Normal power supply| ****
Orange
Blink| PD device failure or power overload
Off| No connected PD or PoE power off
Link
| ****
Network
| On| Link is ok| ****
Green
Blink| The link port is receiving/sending data
Off| Link failure or port failure
Link
| ****
Uplink Network
| On| Link is ok| ****
Green
Blink| The link port is receiving/sending data
Off| Link failure or port failure
SPD
| ****
Port rate
| On| Gigabit transmission| ****
Orange
Off| Non-gigabit transmission
Function Switch
E| 250m| Turn the switch to the symbol, then the function is turned on| Enable
the PoE port 10Mbps/250m long-distance transmission function
V| VLAN| Enable PoE port (1~4) VLAN isolation function
D| Watchdog| Enable the PoE port self-healing network restart (watchdog)
function
Installation Step
-
Remove the switch and accessories from the package.
-
Connect power to the switch. Make sure that Power (PWR) LED is on.
-
Connect your IEEE802.3af/at compliant Power Devices (PD) to Ports 1~4 and the Switch will automatically supply power through these ports (see Figure A).
Note: Port 5 and 6 are Uplink Ports and do not supply PoE Power. -
Check the Port LED indicator status. When a PoE device is connected and the port is supplying power, it light on.
-
For more product information visit www.airlive.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>